Operation
TOUR Notes
Master Dimmer
Red, Green, & Blue
Color Selection
Color Macros
Strobe
Auto
Dimmer Speed
ID Address
Selection
These notes intent to clarify the way the TOUR DMX personality works.
·Channel 1 controls the intensity of the currently projected color.
·When the slider is at the highest position (255) the intensity of the output is at its maximum.
·Channels 2, 3, and 4 control the intensity ratio of each of the Red, Green, and Blue LEDs.
·When the slider is at the highest position (255), the intensity of each color is at its maximum.
·You can combine channels 2, 3, and 4 to create over 16 million colors.
·Channel 5 selects the required Color Macro.
·Channel 5 has priority over channels 2, 3, and 4.
·Channel 1 controls the intensity of the Color Macro.
·Channel 6 controls the strobe frequency (not the intensity) of channels 2~5.
·Channel 6 strobes channels 2, 3, and 4 when not running macros, allowing the individual faders (R, G, and B) as well as channel 1 (D) to control the output intensity.
·Channel strobes channel 6 when running macros, allowing channel 6 to select the macro and channel 1 to control the output intensity.
·Channel 7 selects the preset auto programs AT. 01~10 or the custom programs CUS. 01~10.
·When activating the custom programs CUS. 01~10, it is possible to control the Step Time and Fade Time using channels 2 and 3 respectively.
·Channel 7 has priority over channels 2, 3, 4, 5, and 6.
·Channel 9 is for selecting the dimmer mode and speed. When Dimmer is set to Off, the Red, Green, Blue, and Dimmer outputs are linear with the faders. Otherwise, Dim1 is the fastest dimmer curve, while Dim4 is the slowest.
·Channel 10 selects the target ID address.
·Each independent DMX address may have up to 66 independent ID addresses.
·An ID address of 0 will activate all ID address locations.
COLORado™ |