Crestron electronic Residential Lighting manual CLX Lighting Control Modules

Crestron Residential Lighting Design Guide GreenLight Options–CAEN Enclosures

CLX Lighting Control Modules

Concealed in Crestron automation cabinets, the CLX-series devices are rigorously built using oversized heat sinks for ultimate reliability.

∙Split-bobbin transformers and ground-referenced electronics deliver superior performance

∙Lamp flicker is minimized through the innovative Crestron zero-crossing detection technique, backed by proprietary firmware

∙Low-maintenance convection cooling assures quiet and trouble-free operation

∙Noise suppression inductors and international 230V versions are available

∙LEDs on the modules indicate communication to a Cresnet® network, input power to the module, and output power to the load

∙A five-pin ribbon cable interconnects modules and the processor

NOTE: CLX modules and their associated CLT terminal blocks must be installed into the lowest available spaces and continue toward the top of the enclosure.

CAUTION: A bypass jumper is provided to allow testing and to protect the module during installation. When properly secured by nine screws, the jumper on the black and red section of the terminal block shorts the LINE in to DIM out so that the circuit is energized. Do not remove the bypass jumper until all feed and load wiring has been completed, the circuit has been tested for electrical faults, and the module has been installed. Furthermore, the jumper on the white section of the terminal block ties the neutral in to the neutral outs. This jumper should never be removed.

Doc. 5999F 17