Sanyo THS4232, XHS3632, XHS4232 Using the Remote Control Unit, How to Install Batteries, Do not

Page 11

Using the Remote Control Unit

How to Install Batteries

1. Slide the cover in the direction indicated by the arrow and remove it.

2. Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3. Use a thin object such as the tip of a pen to press the ACL button.

NOTE

ACL button

The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit’s display fails to indicate, or when the remote control cannot be used to change the air conditioner’s settings.

Use two fresh leak-proof type-AAA alkaline batteries.

In replacing batteries, follow the instructions as mentioned in the sub-section “How to Install Batteries”.

If you do not use the remote control unit more than 1 month, take out the batteries.

How to Use the Remote Control Unit

When using the remote control unit, always point the unit’s transmitter head directly at the air conditioner’s receiver.

Air conditioner (Indoor unit)

Receiver

(Transmitter head)

Remote control unit

Remote Control Unit Installation Position

DO NOT

The remote control unit may be operated either from a non-fixed position or from a wall-mounted position.To ensure that the air conditioner operates correctly, DO NOT install the remote control unit in the following places:

In direct sunlight

Behind a curtain or other places where it is covered

More than 26 feet (8 m) away from the air conditioner

In the path of the air conditioner’s airstream

Where it may become extremely hot or cold

Where it may be subject to electrical or magnetic noise

Where there is an obstacle between the remote control unit and air conditioner (since a check signal is sent from the remote control unit every 5 minutes)

OI-212-11EG

11

Image 11 Contents
Split System Heat Pump Features Product Information ContentsElectrical Requirements Installation LocationSafety Instructions Outdoor condensing unit Names of PartsRecessed type Ceiling-mounted type Operation selector Operation Timer StandbyRecessed type Ceiling-mounted type Lamp Control Indoor Unit Remote Control Unit Display and Operation Selector OFF Remote Control Unit Cool Hour OFF TimerAuto HeatDo not Using the Remote Control UnitHow to Install Batteries Remote Control Unit Installation PositionSecuring the remote control unit to prevent theft Using the Remote Control UnitMounting the Remote Control Unit When using the remote control unitPress the ON/OFF operation button Operation with the Remote Control UnitAutomatic Operation StepStep Operation with the Remote Control UnitManual Operation FAN Speed Adjusting the Fan SpeedNight Setback Mode is used for saving energy Fan Only Night Setback ModeTime Set Temperature Pressing 30 minButton Heating Mode Night SetbackSpecial Remarks Setting theTimerRemote Control Unit How to set the present timeHow to set a program for daily ON/OFF operation Setting the TimerCancellation procedure Using the 1-Hour OFFTimerHour OFF Timer Operation Together with the Program Timer Setting procedureCooling Adjusting the Airflow DirectionOperation without the Remote Control Unit Latch Safety string Air intake grille Bolt screw Air filter Care and CleaningHow to remove the filter Ceiling-mounted type Care and CleaningOperating Range TroubleshootingShould the power fail while the unit is running Tips for Energy SavingDivision of Sanyo North America Corporation CanadaSanyo Fisher Company Sanyo Canada Inc
Related manuals
Manual 106 pages 21.57 Kb