Sanyo KHS2432, XHS3632, XHS4232 Care and Cleaning, How to remove the filter Ceiling-mounted type

Care and Cleaning (continued)

How to remove the filter	Ceiling-mounted type:
	1.	Remove the bolt screws on the latch using a screwdriver. (After
		cleaning, be sure to reattach the two bolt screws.)
	2.	Take hold of the two latches on the air intake grille and press them to
		the rear, and the grille will open downward.
	3.	Take hold of the finger-hold on the air filter, first lift it and then pull it
		toward you to release it from the catch.

		Latch	Catch
		Air filter
			Air intake grille
			Air filter finger-hold
How to remove the filter	Wall-mounted type
	1.	Move the flap on the air outlet grille to its lowest position.
	2.	Hold the air filter by the tab at the bottom, and pull downward.

Air filter

Pull down

How to clean the filter

Outdoor Unit

CAUTION

Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.

1.Certain metal edges and the condenser fins are sharp and may cause injury if handled improperly; special care should be taken when you clean these parts.

2.Periodically check the outdoor unit to see if the air outlet or air intake is clogged with dirt or soot.

3.The internal coil and other components of the outdoor unit must also be cleaned periodically. Consult your dealer or service center.

Care: After a Prolonged Idle Period

Care: Before a Prolonged Idle Period

Check the indoor and outdoor unit air intakes and outlets for blockage; if there is a blockage, remove it.

·Operate the fan for half a day to dry out the inside.

·Disconnect the power supply and also turn off the breaker.

·Clean the air filter and replace it in its original position.

·Outdoor unit internal components must be checked and cleaned periodically. Contact your local dealer for this service.

OI-212-23EG 23