Sanyo SHA-KC64UG Only for heat pump type Temperature range 62 ~ 80 F, Cool or, Heat or FAN

■Functions of buttons (Continued)

D: ON button				This button is for turning the selected air conditioner on.
E: OFF button				This button is for turning the selected air conditioner off.
F: Operation lamp				This lamp lights when the unit is turned on.
G: MODE button				Use this button to select one of the following five operations:
	(AUTO)			: Used to automatically set cooling or heating operation.
					Only for heat pump type
										(temperature range: 62 ~ 80 °F)
	(HEAT)			: Used for normal heating operation.
					Only for heat pump type
										(temperature range: 60 ~ 78 °F)
	(DRY)			: Used for dehumidifying without changing the room temperature.
										(temperature range: 64 ~ 86 °F)
	(COOL)			: Used for normal cooling operation.
										(temperature range: 64 ~ 86 °F)
		(FAN)			: Used to run the fan only, without heating or cooling operation.
				When the		indication is displayed, you cannot change the
	NOTE
				mode from		and	or	to	or	and . To change the
				mode, turn off all units once then select the mode again.
H: Temperature					: Press this button to increase the temperature setting.
setting buttons					: Press this button to decrease the temperature setting.
I: FAN SPEED button
	(AUTO)				: The air conditioner automatically decides the fan speed.
			(HI.)		: High fan speed.
	(MED.)				: Medium fan speed.
		(LO.)			: Low fan speed.
J: FLAP button	( )			1. Use this button to set the airflow direction to a specific angle.
				The airflow direction is displayed on the remote control unit.
					Operation mode			Number of airflow direction settings
					(COOL) or		(DRY)			3
					(HEAT) or (FAN)					5
					(AUTO)					3
					Cooling mode:
					Heating mode:					5
					• In the cool mode and dry mode, when the flaps are set in a
					downward position, condensation may form and drip around
					the vent.

•Do not move the flap with your hands.

NOTE		This function is available only for models X and T.
(	)
		2.	Use this button to make the airflow direction sweep up and down
			automatically.
			Press this button several times until the (	) symbol appears on
			the display.
NOTE		This function is available only for models X, K and T.
NOTE		1)	The flap setting can be performed only for units that have no remote
			controllers.
		2)	In the ALL or ZONE mode, no flap setting can be performed. If
			necessary, you should select the GR mode and use the FLAP button.

4

OI-432-04 - 5EG 4 - 5