Cisco Systems 1700 manual Installing the Cards

Chapter 2 Installing the Cisco 1700 Router

Installing the Cards

Follow these steps to install the card in a Cisco 1700 router:

Step 1 Make sure that the power switch is set to the STANDBY position ( ) and that the power cable is not connected to the power socket on the rear panel.

Step 2 Loosen the thumbscrews on the WAN interface card-slot cover on the rear panel, as shown in Figure 2-2.

You should be able to loosen the screws using your fingers; however, if the screws are very tight, you might need to use a Phillips screwdriver.

Figure 2-2 Removing the WAN Interface Card-Slot Cover

Cisco
1720	WIC0	OK

			CONSOLE
FDX	100	LNK
		10/100	ETHERNET
			AUX

WIC1 OK

+5, +12, -12 VDC

WAN interface card slot cover

12158

Step 3 Remove the metal plate that covers the card slot.

Step 4 Hold the WAN interface card by the edges on either side of the card front panel, and line up the card edges with the guides inside the card slot, as shown in Figure 2-3.

	Cisco 1700 Router Hardware Installation Guide
2-6	78-5405-03