Delta 36-441B, 36-451X instruction manual Contractor’s Saw

Page 1

10" Contractor’s Saw

(Models 36-441B, 36-451X)

INSTRUCTION MANUAL

NOTE: Shown with UniRip® Fence System

PART NO. 422-19-651-0058 - 03-22-04

Copyright © 2004 Delta Machinery

To learn more about DELTA MACHINERY

visit our website at: www.deltamachinery.com.

For Parts, Service, Warranty or other Assistance,

please call 1-800-223-7278 (In Canada call 1-800-463-3582).

Image 1

Contents Contractor’s Saw General Safety Rules Safety Guidelines DefinitionsImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Contractor SAWMotor Specifications Power ConnectionsGrounding Instructions Volt Minimum Gauge Extension Cord Extension CordsFunctional Description Unpacking and CleaningForeword Unpacking and Cleaning Rear Leg Panel Assembling SAW Stand SAW AssemblyAssembling SAW to Stand Disconnect Machine from the Power Source Motor AssemblyAssembling Blade Tilting Handwheel Assembling Motor to Motor Mounting PlateAssembling Motor and Motor Mounting Plate to SAW Disconnect Machine from Power SourceTo Motor Mounting Plate Assembling Motor PULLEY, Belt Pulley GUARD, and Drive BeltIllustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyAssembling Blade Guard Splitter Assembly Assembling and Aligning Blade Guard and Splitter AssemblyIf alignment is necessary, loosen the two screws Page Assembling Steel Extension Wing and Switch Model 36-441B Extension and Switch AssemblyAssembling Switch to Cast Iron Extension Wing Assembling Cast Iron ExtensionOperating Controls Fastening Stand to Supporting SurfaceAdjusting 90 Degree and 45 Degree Positive Stops Operation and AdjustmentsRaising and Lowering Blade Tilting the BladeChecking Blade Alignment Adjusting Blade AlignmentBlade Alignment Adjusting Blade Tilting Mechanism Backlash AdjustmentsChanging SAW Blade Miter Gage Operation and Adjustment Adjusting Table InsertCommon Sawing Operations Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGCROSS-CUTTING Constructing a Push Stick RippingUsing Moulding Cutterhead Accessory Moulding CutterheadUsing Dado Head Accessory Dado HeadConstructing a Featherboard Power Tool InstituteConstructing a Push Stick PushstickStorage MaintenanceDust Chute Repositioning Motor For StorageAccessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers