Delta 36-441B, 36-451X instruction manual Rear Leg Panel

Page 9

UNPACKING AND CLEANING Continued

	1		3
		2	4

5

7

23

6

8

22

9 11

10

13

12 15

16

18

17

21

20

19

Fig. 3

14

1.	Combination Dust Chute/Support Panel	12.	5/16" Hex Nuts (4)
2.	Motor Pulley	13.	5/16" Hex Nuts (8)
3.	Motor	14.	5/16" Lockwashers (8)
4.	Pulley Guard	15.	5/16" Flat Washers
5.	Drive Belt	16.	5/16-18 x 5/8" Hex Head Bolts (8)
6.	Spring	17.	Rubber Feet (4)
7.	Pins (2) for Mounting Motor	18.	#10-32 x 12 Screws (8)
8.	Motor Mounting Plate	19.	#10 Keps Nuts (8)
9.	5/16 Star Washers (4)	20.	#10-1/2" Sheet Metal Screws (3)
10.	5/16 Flat Washers (4)	21.	Grommet
11.	5/16-18 x 3/4" Carriage Head Screws (4)	22.	Front Leg Panel with WARNING Label
		23.	Rear Leg Panel

9

Image 9

Contents Contractor’s Saw Safety Guidelines Definitions General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Contractor SAWPower Connections Motor SpecificationsGrounding Instructions Volt Minimum Gauge Extension Cord Extension CordsUnpacking and Cleaning Functional DescriptionForeword Unpacking and Cleaning Rear Leg Panel SAW Assembly Assembling SAW StandAssembling SAW to Stand Disconnect Machine from the Power Source Motor AssemblyAssembling Blade Tilting Handwheel Assembling Motor to Motor Mounting PlateAssembling Motor and Motor Mounting Plate to SAW Disconnect Machine from Power SourceTo Motor Mounting Plate Assembling Motor PULLEY, Belt Pulley GUARD, and Drive BeltIllustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyAssembling Blade Guard Splitter Assembly Assembling and Aligning Blade Guard and Splitter AssemblyIf alignment is necessary, loosen the two screws Page Assembling Steel Extension Wing and Switch Model 36-441B Extension and Switch AssemblyAssembling Switch to Cast Iron Extension Wing Assembling Cast Iron ExtensionOperating Controls Fastening Stand to Supporting SurfaceAdjusting 90 Degree and 45 Degree Positive Stops Operation and AdjustmentsRaising and Lowering Blade Tilting the BladeAdjusting Blade Alignment Checking Blade AlignmentBlade Alignment Backlash Adjustments Adjusting Blade Tilting MechanismChanging SAW Blade Miter Gage Operation and Adjustment Adjusting Table InsertNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Common Sawing OperationsCROSS-CUTTING Constructing a Push Stick RippingUsing Moulding Cutterhead Accessory Moulding CutterheadUsing Dado Head Accessory Dado HeadConstructing a Featherboard Power Tool InstituteConstructing a Push Stick PushstickStorage MaintenanceDust Chute Repositioning Motor For StorageAccessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers