Delta 36-441B, 36-451X instruction manual Assembling and Aligning Blade Guard and Splitter Assembly

Page 15

ASSEMBLING AND ALIGNING

BLADE GUARD AND SPLITTER ASSEMBLY

ASSEMBLING

BLADE GUARD AND

SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM POWER SOURCE.

B

A

1.Fasten the rear splitter mounting bracket (A) Fig. 24, to the rear trunnion using the two 1/4-20 x 3/4" hex head bolts (B) and flat washers. Do not completely tighten the two bolts (B) at this time.

2.Raise saw arbor to its highest position. With wrenches supplied, remove the saw blade from the saw. Refer to section “CHANGING THE SAW BLADE” of this manual.

3.Remove bolt and large washer (C) Fig. 25, from the inside splitter mounting bracket.

4.Use a straight edge (E) to check to see if the top and bottom of the inside splitter bracket (D) Fig. 26 is aligned with the inner arbor flange (F).

Fig. 24

C

Fig. 25

D

F

E

Fig. 26

15

Image 15

Contents Contractor’s Saw Safety Guidelines Definitions General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Contractor SAWPower Connections Motor SpecificationsGrounding Instructions Volt Minimum Gauge Extension Cord Extension CordsUnpacking and Cleaning Functional DescriptionForeword Unpacking and Cleaning Rear Leg Panel SAW Assembly Assembling SAW StandAssembling SAW to Stand Assembling Motor to Motor Mounting Plate Motor AssemblyDisconnect Machine from the Power Source Assembling Blade Tilting HandwheelAssembling Motor and Motor Mounting Plate to SAW Disconnect Machine from Power SourceTo Motor Mounting Plate Assembling Motor PULLEY, Belt Pulley GUARD, and Drive BeltIllustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyAssembling Blade Guard Splitter Assembly Assembling and Aligning Blade Guard and Splitter AssemblyIf alignment is necessary, loosen the two screws Page Assembling Cast Iron Extension Extension and Switch AssemblyAssembling Steel Extension Wing and Switch Model 36-441B Assembling Switch to Cast Iron Extension WingOperating Controls Fastening Stand to Supporting SurfaceTilting the Blade Operation and AdjustmentsAdjusting 90 Degree and 45 Degree Positive Stops Raising and Lowering BladeAdjusting Blade Alignment Checking Blade AlignmentBlade Alignment Backlash Adjustments Adjusting Blade Tilting MechanismChanging SAW Blade Miter Gage Operation and Adjustment Adjusting Table InsertNever USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Common Sawing OperationsCROSS-CUTTING Constructing a Push Stick RippingUsing Moulding Cutterhead Accessory Moulding CutterheadUsing Dado Head Accessory Dado HeadConstructing a Featherboard Power Tool InstituteConstructing a Push Stick PushstickRepositioning Motor For Storage MaintenanceStorage Dust ChuteAccessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers