Delta 36-441B, 36-451X instruction manual

Page 17

9.With the blade guard (L) Fig. 31, in the raised position, assemble the saw blade (K) on the saw arbor and tighten securely with two arbor wrenches supplied. See section “CHANGING SAW BLADE.”

10.Use a straight edge (E) to check to see if the saw blade is aligned with the rear of the splitter (G) in Figs. 32 and 33. If alignment is necessary, loosen the bolts (A) Fig. 33, align splitter (G) with the saw blade, and tighten two bolts (A).

11.Lower saw blade and install table insert (P) Fig. 34, in the saw table. IMPORTANT: When installing the table insert, make certain to hold on to the blade guard (L). The insert will automatically release the holding action on the splitter and lower the blade guard when the insert is installed in the table opening.

L

K

Fig. 31

G

E

Fig. 32

G

A

Fig. 33

L

P

Fig. 34

17

Image 17
Contents Contractor’s Saw Important Safety Instructions Safety Guidelines DefinitionsGeneral Safety Rules Stay ALERT, Watch What YOU are DOING, Properly Support Long or Wide workpieces Additional Safety Rules for Contractor SAWGrounding Instructions Power ConnectionsMotor Specifications Volt Minimum Gauge Extension Cord Extension CordsForeword Unpacking and CleaningFunctional Description Unpacking and Cleaning Rear Leg Panel Assembling SAW to Stand SAW AssemblyAssembling SAW Stand Disconnect Machine from the Power Source Motor AssemblyAssembling Blade Tilting Handwheel Assembling Motor to Motor Mounting PlateAssembling Motor and Motor Mounting Plate to SAW Disconnect Machine from Power SourceTo Motor Mounting Plate Assembling Motor PULLEY, Belt Pulley GUARD, and Drive BeltIllustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyAssembling Blade Guard Splitter Assembly Assembling and Aligning Blade Guard and Splitter AssemblyIf alignment is necessary, loosen the two screws Page Assembling Steel Extension Wing and Switch Model 36-441B Extension and Switch AssemblyAssembling Switch to Cast Iron Extension Wing Assembling Cast Iron ExtensionOperating Controls Fastening Stand to Supporting SurfaceAdjusting 90 Degree and 45 Degree Positive Stops Operation and AdjustmentsRaising and Lowering Blade Tilting the BladeBlade Alignment Adjusting Blade AlignmentChecking Blade Alignment Changing SAW Blade Backlash AdjustmentsAdjusting Blade Tilting Mechanism Miter Gage Operation and Adjustment Adjusting Table InsertCROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTINGCommon Sawing Operations Constructing a Push Stick RippingUsing Moulding Cutterhead Accessory Moulding CutterheadUsing Dado Head Accessory Dado HeadConstructing a Featherboard Power Tool InstituteConstructing a Push Stick PushstickStorage MaintenanceDust Chute Repositioning Motor For StorageAccessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers