Delta 36-451X, 36-441B Extension and Switch Assembly, Assembling Cast Iron Extension

(MODEL 36-441B,36-451X)

EXTENSION AND SWITCH ASSEMBLY

ASSEMBLING CAST IRON EXTENSION

WING (MODEL 36-441B, 36-451X)

DISCONNECT MACHINE FROM POWER

C

SOURCE.

1.Assemble extension wing (A) Fig. 35, to the saw table using three 7/16-20 x 1-1/4" bolts (B) and lockwashers (C) Fig. 35.

B

A

D

2.With a straight edge (D) Fig. 35, make certain the extension wing (A) is level with the saw table before tightening three bolts (B) Fig. 36.

ASSEMBLING SWITCH TO CAST IRON EXTENSION WING

DISCONNECT MACHINE FROM POWER SOURCE.

1.Assemble switch (A) Fig. 37, behind the lip of extension wing (B) insert 5/16-18 x 1" flat head screw (C), then assemble flat washer, and locknut. Tighten securely.

2.Fig. 38 illustrates the switch assembled to the extension wing.

C

B

A

Fig. 37

ASSEMBLING STEEL EXTENSION

Fig. 35

B

Fig. 36

Fig. 38

C

D

BC

WING AND SWITCH (MODEL 36-441B)

DISCONNECT MACHINE FROM POWER

A

B

SOURCE.

1.Assemble extension wing (A) Fig. 39, to the saw table using three 7/16-20 x 3/4" bolts (B) and flat washers (C).

2.With a straight edge (D) Fig. 39, make certain the extension wing (A) is level with the saw table before tightening three bolts (B).

3.Loosely assemble switch bracket (E) Fig. 40, to the rear of extension wing (A) and fasten with 3/8-16 x 1" long carriage head bolt through hole, then add flat washer, and hex nut (S). Tighten after fence rail is assembled.

Fig. 39

S

A

E

Fig. 40

18