Schumacher XC6, XCS15, XC10, XC12 owner manual Personal Precautions Risk of Explosive Gases

Page 3

1.10To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the manufacturer of any equipment you intend to use in the vicinity of the battery. Review the cautionary markings on these products and on the engine.

1.11This charger employs parts, such as switches and circuit breakers, that tend to produce arcs and sparks. If used in a garage, locate this charger 18 inches or more above floor level.

2.PERSONAL PRECAUTIONS

RISK OF EXPLOSIVE GASES.

2.1NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.

2.2Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead-acid battery. A lead-acid battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.

2.3Be extra cautious to reduce the risk of dropping a metal tool onto the battery. It might spark or short-circuit the battery or other electrical part that may cause an explosion.

2.4Use this charger for charging LEAD-ACID batteries only. It is not intended to supply power to a low voltage electrical system other than in a starter-motor application. Do not use this battery charger for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage to property.

2.5NEVER charge a frozen battery.

2.6NEVER overcharge a battery.

2.7Consider having someone close enough by to come to your aid when you work near a lead-acid battery.

2.8Have plenty of fresh water and soap nearby in case battery acid contacts your skin, clothing or eyes.

2.9Wear complete eye and body protection, including safety goggles and protective clothing. Avoid touching your eyes while working near the battery.

2.10If battery acid contacts your skin or clothing, immediately wash the area with soap and water. If acid enters your eye, immediately flood the eye with cold running water for at least 10 minutes and get medical attention right away.

2.11If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT induce vomiting. Seek medical attention immediately.

3.PREPARING TO CHARGE

RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS

A HIGHLY CORROSIVE SULFURIC ACID.

3.1If it is necessary to remove the battery from the vehicle to charge it, always remove the grounded terminal first. Make sure all of the accessories in the vehicle are off to prevent arcing.

3.2Be sure the area around the battery is well ventilated while the battery is being charged.

3.3Clean the battery terminals before charging the battery. During cleaning, keep airborne corrosion from coming into contact with your eyes, nose and mouth. Use baking soda and water to neutralize the battery acid and help eliminate airborne corrosion. Do not touch your eyes, nose or mouth.

3.4Add distilled water to each cell until the battery acid reaches the level specified by the battery manufacturer. Do not overfill. For a battery without removable cell caps, such as valve regulated lead acid batteries (VRLA), carefully follow the manufacturer’s recharging instructions.

3.5Read, understand and follow all instructions for the charger, battery, vehicle and any equipment used near the battery and charger. Study all of the battery manufacturer’s specific precautions while charging and recommended rates of charge.

3.6Determine the voltage of the battery by referring to the vehicle owner’s manual.These chargers are equipped with autovoltage detection of 6 or 12 volts only.

3.7Make sure that the charger cable clips make tight connections.

2

Image 3
Contents Models / Modelos XC6, XC10, XC12 & XCS15 Risk of Explosive Gases Risk of Electric Shock or FirePersonal Precautions Risk of Explosive Gases DC Connection Precautions Risk of Electric Shock or Fire ConnectedCharging Charge Rate Button Battery Connection IndicatorAutomatic Charging Mode Digital Display models XC12 and XCS15Using the Battery Voltage Tester Models XC12 and XCS15 only Desulfation ModeMaintain Mode Float-Mode Monitoring Maintaining a Battery 2A Charge RateCalculating charge time Model XC6Model XC10 Moving and Storage Instructions Maintenance InstructionsModel XC12 Model XCS15Problem Possible Cause Solution Troubleshooting Failure CodesError Description REASON/SOLUTION Code TroubleshootingBefore Returning for Repairs Limited warranty Warranty not valid in MexicoDo not Return this Product to the Store Mail To Business Center DriveMount Prospect, IL Page EL Riesgo DE Descarga Eléctrica O Incendio AdvertenciaPrecauciones Personales Riesgo DE Gases Explosivos Riesgo DE Gases ExplosivosPrecauciones DE Conexión EN CC Conexiones a tierra y energía de CA LED Cargando Instrucciones Para EnsamblePanel DE Control LED ConectadaInstrucciones DE Operación Modo de mantenimiento Monitoreo a modo de flote Mantenimiento de la Batería 2A nivel de cargaIndicación de Condición de la Modelo XC12 Calculando EL Tiempo DE CargaModelo XC6 Modelo XC10Instrucciones para el manejo y almacenamiento Código Descripción RAZÓN/SOLUCIÓN ErrorModelo XCS15 Instrucciones DE MantenimientoProblema Posible Causa Solución Localización y Solución de ProblemasAntes DE Devolver EL Cargador Para Reparación ¡NO LO Devuelva este producto a LA Tienda