Schumacher XC12, XCS15, XC10 Troubleshooting Failure Codes, Error Description REASON/SOLUTION Code

Page 10

15.Troubleshooting Failure Codes

ERROR

DESCRIPTION

REASON/SOLUTION

CODE

 

 

 

 

 

 

The battery voltage is still

Could be caused by trying to charge a 6

F01

under 10V (for a 12V battery)

volt battery on the 12 volt setting, or the

or 5V (for a 6V battery) after 2

battery could be bad, have it checked or

 

 

hours of charging.

replaced.

F02

The charger cannot desulfate

The battery could not be desulfated, have it

the battery.

checked or replaced.

 

 

 

Could be caused by trying to charge a

 

The battery was unable

large battery or bank of batteries on too

 

low of a current setting or the battery may

F03

to reach the “full charged”

have a shorted cell. Try again with a higher

 

voltage.

 

current setting or have the battery checked

 

 

 

 

or replaced.

 

The connections to the

The battery is connected backwards.

F04

Unplug the charger and reverse the

battery are reversed.

 

connections to the battery.

 

 

 

 

The battery won’t hold a charge. Could

 

The charger was unable to

be caused by a drain on the battery or the

 

battery could be bad. Make sure there are

F05

keep the battery fully charged

no loads on the battery. If there are remove

 

in maintain mode.

 

them. If there are none, have the battery

 

 

checked or replaced.

If you get a failure code, you have to check the connections and settings and/or replace the battery.

Troubleshooting

PROBLEM

POSSIBLE CAUSE

SOLUTION

Connected light is

The battery is not connected

Check for poor connection

not on.

correctly.

to battery and frame. Make

 

 

sure connection points are

 

 

clean. Rock clips back and

 

 

forth for a better connection.

CHARGING light is

Charger is in abort mode.

Reset the charger by

blinking.

Battery may also be faulty.

unplugging it. Select the

 

This will happen if the

desired CHARGE RATE and

 

battery did not reach full

BATTERY TYPE again, if

 

charge within 48 hours.

necessary.

 

May be due to a very large

 

 

battery or a bank of batteries

 

 

requiring more power than

 

 

the charger can deliver in 48

 

 

hours.

 

The CHARGED light

The battery may be fully

If the battery is in a vehicle,

turns on a few minutes or

charged or recently charged,

turn the headlights on for

less after connecting the

leaving the battery voltage

a few minutes to reduce

battery.

high enough to appear to be

the battery voltage and try

 

fully charged.

charging again. Also try

 

 

a lower CHARGE RATE

 

 

selection.

 

The battery may be faulty

A sulfated battery will

 

(sulfated).

eventually accept a charge.

 

 

Continue charging for a

 

 

few hours. If not, have the

 

 

battery checked or call

 

 

customer service.

9

Image 10
Contents Models / Modelos XC6, XC10, XC12 & XCS15 Risk of Electric Shock or Fire Risk of Explosive GasesPersonal Precautions Risk of Explosive Gases DC Connection Precautions Connected Risk of Electric Shock or FireCharging Digital Display models XC12 and XCS15 Battery Connection IndicatorAutomatic Charging Mode Charge Rate ButtonMaintaining a Battery 2A Charge Rate Desulfation ModeMaintain Mode Float-Mode Monitoring Using the Battery Voltage Tester Models XC12 and XCS15 onlyModel XC6 Calculating charge timeModel XC10 Model XCS15 Maintenance InstructionsModel XC12 Moving and Storage InstructionsTroubleshooting Troubleshooting Failure CodesError Description REASON/SOLUTION Code Problem Possible Cause SolutionLimited warranty Warranty not valid in Mexico Before Returning for RepairsDo not Return this Product to the Store Business Center Drive Mail ToMount Prospect, IL Page Advertencia EL Riesgo DE Descarga Eléctrica O IncendioRiesgo DE Gases Explosivos Precauciones Personales Riesgo DE Gases ExplosivosPrecauciones DE Conexión EN CC Conexiones a tierra y energía de CA LED Conectada Instrucciones Para EnsamblePanel DE Control LED CargandoInstrucciones DE Operación Mantenimiento de la Batería 2A nivel de carga Modo de mantenimiento Monitoreo a modo de floteIndicación de Condición de la Modelo XC10 Calculando EL Tiempo DE CargaModelo XC6 Modelo XC12Instrucciones DE Mantenimiento Código Descripción RAZÓN/SOLUCIÓN ErrorModelo XCS15 Instrucciones para el manejo y almacenamientoLocalización y Solución de Problemas Problema Posible Causa SoluciónAntes DE Devolver EL Cargador Para Reparación ¡NO LO Devuelva este producto a LA Tienda