Ingersoll-Rand 7802A Product Safety Information, Product Specifications, Parts and Maintenance

EN

Product Safety Information

Intended Use:

These Drills are designed for drilling, valve guide reaming and cylinder honing operations in the automotive industry.

For additional information refer to Air Drill Product Safety Information Manual Form 04580353. Manuals can be downloaded from www.irtools.com.

Product Specifications

		Free	Chuck	Sound Level dB (A)		Vibration
						Level
	Handle	Speed	Capacity	(ISO15744)
Model(s)						(ISO8662)
	Type
		rpm	inches (mm)	Pressure (Lp)	Power (Lw)	m/s²
				“KpA”=3dB(A)	“KwA”=3dB(A)
7802A	Pistol	2000	3/8" (10)	83.0	94.0	0.2
7803A	Pistol	500	1/2" (13)	83.0	94.0	0.3
7802RA	Pistol	2000	3/8” (10)	83.0	94.0	0.4
7803RA	Pistol	500	1/2” (13)	83.0	94.0	0.3

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling disconnects. See drawing 16573180 and table on page 2. Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items identified as:

1.	Air filter	6.	Thread size
2.	Regulator	7.	Coupling
3.	Lubricator	8.	Safety Air Fuse
4.	Emergency shut-off valve	9.	Oil
5.	Hose diameter	10.	Grease - through fitting

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that they can be recycled.

The original language of this manual is English.

Tool repair and maintenance should only be carried out by an authorized Service Center.

Refer all communications to the nearest Ingersoll-RandOffice or Distributor.

04580452_ed4 EN-1