Makita LSSOODWA, LSSOODZ instruction manual Maintaining maximum cutting capacity

Page 14

Kerf board

Left bevel cut

Straight cut

CAUTION:

After changing the bevel angle, always readjust the kerf boards as described above.

Maintaining maximum cutting capacity

This tool is factory adjusted to provide the max. cutting capacity for a 216 mm (8-1/2") saw blade. When using a saw blade other than 216 m m (8-1/2") saw blade, adjust the lower limit position of the blade as follows:

First, remove the battery cartridge. Push the carriage toward the guide fence fully and lower the handle completely. Use the socket wrench to turn the adjusting bolt until the periphery of the blade extends slightly below the top surface of the turn base at the point where the front face of the guide fence meets the top surface of the turn base. With the battery cartridge removed, rotate the blade by hand while holding the handle all the way down to be sure that the blade does not contact any part of the lower base. Re-adjust slightly, if necessary.

Turn base Adjusting bolt

Periphery of blade

I Top surface

I

Guide fence

Guide fence

CAUTION:

After installing a new blade, always be sure that the blade does not contact any part of the lower base when the handle is lowered completely. Always do this with the battery cartridge removed.

14

Image 14
Contents With High Capacity Battery Charger Cordless Compound Miter SawSpecifications Save it for future reference Page Additional Safety Rules Important Safety Instructions For Charger & Battery Cartridge Installing or removing battery cartridge ChargingInstalling auxiliary plate Trickle charge MaintenancechargeTips for maintaining maximum battery life Socket wrench Bench mounting sawInstalling or removing saw blade Safety cover Dust bag Positioning kerf boardMaintaining maximum cutting capacity Securingworkpiece Positioningfor adjusting the miter anglePositioningfor adjusting the bevel angle Horizontalvise optionalaccessory Vertical viseHoldersand holder assembly optionalaccessories Switch actionOperation Press cutting cutting small workpiecesCompound cutting Miter cuttingBevel cutting Cutting crown and cover moldings Fig. C52/38 type 45O type Miter and Bevel Angle Settings Compound Miter SawCompound Miter Saw Miter and Bevel Angle Settings Wall to Crown Molding Angle 45 degreesCutting repetitive lengths CarryingtoolAdjusting the cutting angle Miter angleBevel angle Replacing carbon brushes Recycling the Battery Accessories Part No.192828-1 Cordless Compound Miter SAW Tiex Makita Corporation of America