When cutting crown and cove moldings, set the bevel angle and miter angle as indicated
in the table (A)and position the moldings on the top surface of the saw base as indicated in the table (B).
| Table (AI |
|
| |
Molding position | Bevel angle | Miter angle | ||
|
|
|
| |
in Fig. (C) | 52/38'' type | 45O type | 52/38'' type | 45' type |
| ||||
For inside corner
Left 33.9O Left 30'
(3)
Moldingpos'tion |
| Molding edge against guide fence | |
in Fig (C) |
|
| |
|
|
| |
1 | li, | I | Ceilinq contact edqe should be |
l?i | against guide fence. | ||
For inside corner |
| I |
|
|
|
| |
|
|
| Wall contact edge should be |
|
|
| against guide fence. |
For outside corner | a |
| Ceiling contact edge should be |
|
| ||
|
| against guide fence. | |
Right 31.6" | Right 35.3' |
Finished piece
Finished piece will be on the Left side of blade.
Finished piece will be on the
Right side Of blade'
(Example)
In the case of cutting 52/38' type crown molding for position 0 in Fig. (C): *Tilt and secure bevel angle setting to 33.9O LEFT.
*Adjust and secure miter angle setting to 31.6O RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its CEILING CONTACT EDGE against the guide fence on the saw.
*The finished piece to be used will always be on the LEFT side of the blade after the cut has been made.
21