Makita LSSOODZ, LSSOODWA instruction manual Dust bag, Positioning kerf board

Page 13

Dust bag

The use of the dust bag makes cutting7Dust nozzle operations clean and dust collection easy.

To attach the dust bag, fit the bag's entry port over the dust nozzle. When the dust bag is about half full, remove the dust bag from the tool and pull the fastener out. Empty the dust bag of its contents, tapping it lightly so as to remove particles adhering to the insides which might hamper further collection.

NOTE:

If you connect a Makita vacuum cleaner to your saw, more efficient and cleaner operations can be performed.

Positioning kerf board

This tool is provided with the kerf boards in the turn base. The kerf boards are factory adjusted so that the saw blade does not contact the kerf boards. Before use, adjust the kerf boards as follows:

First, remove the battery cartridge. Loosen the all screws (2 each on left and right) secur- ing the kerf boards. Re-tighten them to the extent that the kerf boards can be easily moved by hand. Lower the handle fully and push in the stopper pin to lock the handle in the lowered position. Pull the carriage

toward you fully. Adjust the kerf boards so that the kerf boards just contact the sides of blade teeth slightly. Tighten the front screws (do not tighten firmly). Push the car- riage toward the guide fence fully and adjust the kerf boards so that the kerf boards just contact the sides of blade teeth slightly. Tighten the rear screws (do not tighten firmly). After adjusting the kerf boards, release the stopper pin and raise the handle. Then tighten the all screws securely.

13

Image 13
Contents Cordless Compound Miter Saw With High Capacity Battery ChargerSpecifications Save it for future reference Page Additional Safety Rules Important Safety Instructions For Charger & Battery Cartridge Charging Installing or removing battery cartridgeTips for maintaining maximum battery life Trickle charge MaintenancechargeInstalling auxiliary plate Bench mounting saw Socket wrenchInstalling or removing saw blade Safety cover Positioning kerf board Dust bagMaintaining maximum cutting capacity Positioningfor adjusting the bevel angle Positioningfor adjusting the miter angleSecuringworkpiece Vertical vise Horizontalvise optionalaccessorySwitch action Holdersand holder assembly optionalaccessoriesPress cutting cutting small workpieces OperationBevel cutting Miter cuttingCompound cutting Fig. C Cutting crown and cover moldings52/38 type 45O type Compound Miter Saw Miter and Bevel Angle SettingsWall to Crown Molding Angle 45 degrees Compound Miter Saw Miter and Bevel Angle SettingsCarryingtool Cutting repetitive lengthsMiter angle Adjusting the cutting angleBevel angle Replacing carbon brushes Recycling the Battery Accessories Part No.192828-1 Cordless Compound Miter SAW Tiex Makita Corporation of America