When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times.
If you charge a battery cartridge from a
If the charging light flashes alternately in green and red color, a problem exists and charg- ing is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.
Trickle charge (Maintenancecharge)
If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its ”trickle charge (maintenancecharge)” mode and keep the battery cartridge fresh and fully charged.
Tips for maintaining maximum battery life
1.Charge the battery cartridge before completely discharged.
Always stop tool operation and charge the battery cartridge when you notice less tool power.
2.Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life.
3.Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F) Let a hot battery cartridge cool down before charging it.
Installing auxiliary plate
Install the auxiliary plate using the notch in the tool‘s base and secure it by tightening the hex. bolt.
Base
Auxiliary plate Base
- z FHex boltTAuxiliaryDplate | Hex bolt Nut |
9