1.Vertical vise
The vertical vise can be installed in two positions on either the left or right side of the guide fence, or the holder assem- bly (optional accessory).
Insert the vise rod into the hole in the guide fence or the holder assembly and tighten the screw to secure the vise rod. (Note: When using the holder assembly, install it on the holder as shown in the figure.)
Position the vise arm according to the
thickness and shape of the workpiece
and secure the vise arm by tighteningTurn base the screw.
Make sure that no part of the tool contacts the vise when lowering the handle fully or when pulling or pushing the carriage. If some part contacts the vise, reposition the vise. Press the workpiece flat against the guide fence and the turn base. Position the workpiece at the desired cutting position and secure it firmly by tightening the vise knob. The maximum thickness of workpieces which can be secured by the vertical vise is 61 mm
2.Horizontalvise (optionalaccessory)
The horizontal vise can be installed on the left side of the base. By turning the vise knob counterclockwise, the screw is released and the vise shaft can be moved rapidly in and out. To grip workpieces, turn the vise knob gently clockwise until the projection reaches its topmost position, then fasten securely. If the vise knob is forced in or pulled out while being turned clockwise, the projection may stop a t an angle. In this case, turn the vise knob back counterclockwise until the screw is released, before turning again gently clockwise. The maximum width of workpieces which can be secured by the horizontal vise is 120 mm
I
Vise knob
Vise shaft i rProjection
16