Make sure that the pointer on the arm points to 0" on the bevel scale on the arm holder. If it does not point to 0", loosen the screw which secures the pointer and adjust the pointer so that it will point to 0".
ii)45" bevel angle
Adjust the 45" bevel angle only after performing 0" bevel angle adjustment. To adjust left 45" bevel angle, loosen the lever and tilt the blade 45" to the left. Make sure that the pointer on the arm points to 45" on the bevel scale on the arm holder. If the pointer does not point to 45", turn the 45" bevel angle adjusting bolt (upper bolt) on the right side of the arm until the pointer points to 45".
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon
brushes.
/
45" bevel angle adjusting bolt
/ | Limit mark |
27