Make sure that the pointer points to 0" I on the miter scale. .If the pointer does not point to 0", loosen the screw which secures the pointer and adjust the point- er so that it will point to 0".
I I I I
Miter.scale Pointer
2)Bevel angle
i)0" bevel angle
Push the carriage toward the guide fence and tighten the clamp screw to secure the carriage. Lower the handle fully and lock it in the lowered position by pushing in the lock pin. Loosen the lever at the rear of the tool. Turn the 0" bevel angle adjusting bolt (lower bolt) on the right side of the arm two or three revolutions counterclockwise to tilt the blade to the right.
Carefully square the side of the blade with the top surface of the turn base using the triangular rule, try square, etc. by turning the 0" bevel angle adjusting bolt clockwise. Then tighten the lever securely.
0"bevel angle adjusting bolt
Triangular rule
I
of turn base
26