Makita LS0714FL Repair Mounting turn base to base, Mounting square rod and securing ring

Page 10
Arm is mounted here.

P 10/ 26

Repair

[9] Mounting turn base to base

1.Apply grease to slide plate and boss for accepting the turn base's axis. Refer to Fig. 2.

2.Fasten hex lock nut M8-13 so that the turn base can move smoothly without wobbling. Refer to Fig. 8-2.

[10] Mounting square rod and securing ring 26

1.Setting ring 26 to pipe 25-235 of arm holder complete, mount arm holder complete to turn base. See Fig. 9-1.

2.Slide arm holder complete so that each end of the two pipes come nearer to the axis of turn base. See Fig. 9-2.

3.Secure square rod to pipes of arm holder complete with hex bolt M5x30.

Fig. 9-1

Pipe 25-235 of

arm holder complete

Fig. 9-2

<Note > Rubber pin has to face arm mounted side.

Rubber pin

Ring 26

Turn base

Arm holder complete

<Note>

For easy mounting, slide ring 26 closely to arm mounted side in this step.

Hex bolt M5x30 Square rod

Hex bolt M5x30

Axis of turn base

Arm is mounted here.

4.Slide ring 26 toward turn base and align the following holes for thumb screw M6x33 and hex socket head bolt M4x10.

*Screw hole of turn base (upper side)

*Screw holes of ring 26

*Screw hole of turn base (bottom side)

And tighten thumb screw M6x33 to secure ring 26 to turn base. See Fig. 9-3.

5.Tighten hex socket head bolt M4x10 from the bottom side of turn base. Then ring 26 is completely secured to turn base.

Fig. 9-3

Arm holder complete

Thumb screw M6x33

Screw hole of turn base (upper side) Screw hole of ring 26

Screw hole of turn base (bottom side)

Ring 26

Hex socket head bolt M4x10

Image 10
Contents Specification Technical InformationOptional accessories Standard equipmentRepair LubricationRepair Page Stopper pin Repair 5Adjusting the return force of torsion spring Assembling safety lock mechanismRepair Assembling safety cover section Repair Removing turn base from base Repair Mounting turn base to base Mounting square rod and securing ringRepair Disassembling positive lock mechanism of turn base Assembling positive lock mechanism of turn baseRepair Mounting stopper plate to arm holder Adjusting arm for smooth pivot actionMounting ring 26 and set screw M4x8 Repair Angle adjustment of saw blade Adjustment for max. cutting capacityRepair Angle adjustment of guide fence Assembling laser section exclusively for LS0714FL/ LS0714L Laser circuitMechanism for adjustment of the position of laser line Repair Page Repair Repair Brush Holder a Holder B Wiring diagram in Handle L LS0714FL with Fluorescent light and laser markerCircuit diagram LS0714F with Fluorescent light Wiring diagram in handle L LS0714F with Fluorescent lightCircuit diagram LS0714 without Fluorescent light and laser Circuit diagram LS0714L with laser marker Wiring diagram in Handle L LS0714L with laser marker