Makita LS0714F Repair Angle adjustment of saw blade, Adjustment for max. cutting capacity

Page 13

P 13/ 26

Repair

[16] Angle adjustment of saw blade

1.Adjust the angle of saw blade at 90° against turn base using 90 degrees set square (Makita Part No.1R208). See Fig. 15-1. While keeping this condition, fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm. See Fig. 15-2.

2.As for 45° degrees adjusting, use 45 degrees set square as Fig. 15-3.

After that the fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm as Fig. 15-4.

Fig. 15-1

1R208 : 90 degrees set square

90°

Fig. 15-3

1R207 : 45 degrees set square

45°

[17] Adjustment for max. cutting capacity

Fig. 15-2

Arm

90°

0 degrees bevel angle adjusting bolt (Hex bolt M6x16)

Fig. 15-4

Arm

45°

45 degrees bevel angle adjusting bolt (Hex bolt M6x16)

Do the following steps to obtain the max. cutting capacity.

1.Pull the motor unit to your side until it stops.

2.Lower the motor unit until it stops.

3.And then adjust the Ø190mm saw blade so that it comes to the position shown in Fig. 16.

Note: The saw blade must not contact kerf boards and base, when the motor unit is in the lowest position. 4. Tighten hex bolt M6x16 using socket wrench 10.

Fig. 16

Socket wrench 10

(Standard equipment)

Hex bolt M6x16

ø190mm saw blade

Kerf board

Image 13
Contents Technical Information SpecificationStandard equipment Optional accessoriesLubrication RepairRepair Page Stopper pin Assembling safety lock mechanism Repair 5Adjusting the return force of torsion springRepair Assembling safety cover section Repair Removing turn base from base Mounting square rod and securing ring Repair Mounting turn base to baseAssembling positive lock mechanism of turn base Repair Disassembling positive lock mechanism of turn baseRepair Mounting stopper plate to arm holder Adjusting arm for smooth pivot actionMounting ring 26 and set screw M4x8 Adjustment for max. cutting capacity Repair Angle adjustment of saw bladeRepair Angle adjustment of guide fence Laser circuit Assembling laser section exclusively for LS0714FL/ LS0714LMechanism for adjustment of the position of laser line Repair Page Repair Repair Brush Holder a Holder B LS0714FL with Fluorescent light and laser marker Wiring diagram in Handle LWiring diagram in handle L LS0714F with Fluorescent light Circuit diagram LS0714F with Fluorescent lightCircuit diagram LS0714 without Fluorescent light and laser Circuit diagram LS0714L with laser marker Wiring diagram in Handle L LS0714L with laser marker