Makita LS0714FL Repair Mounting stopper plate to arm holder, Mounting ring 26 and set screw M4x8

P 12/ 26

Repair

[13] Mounting stopper plate to arm holder

Mount stopper plate as illustrated in Fig. 12.

Fig. 12

Arm holder	Insert this tail into the small hole
	of stopper plate.
Stopper plate
Flat washer 6	Pan head screw M5
	Torsion spring 8

Arm holder

Stopper plate

Flat washer 6

Torsion spring 8

Pan head screw M5

[14] Mounting ring 26 and set screw M4x8

1.Insert ring 26 into the hole of arm. See Fig. 13.

2.Drive set screw M4x8 into the screw hole of arm by screwing thumb screw M6x33 with hex wrench. Stop driving the set screw at the same time it reaches surface A.

Fig. 13

			Thumb screw M6x33
			Hex wrench
Screw hole for	Arm		Set screw M4x8
thumb screw M6x33	Ring 26
Hex wrench		Set screw M4x8
		Screw hole of
		arm	Ring 26
		Surface A
			Arm

[15] Adjusting arm for smooth pivot action

1.Adjust hex lock nut M10x17 so that arm can pivot smooth without backlash. See Fig. 14-1.

2.Mount lever 100 and the relevant parts to arm with keeping the lever angle in lock position as Fig. 14-2.

Fig. 14-1

Arm

Hex lock nut M10-17

Arm holder

Fig. 14-2

	Arm
	Flat washer 10
	Lever 100
Approx 10° against	Compression spring 5
horizontal plane	Hex nut M10-17
	Pan head screw M4x10