Makita LS0714L, LS0714FL dimensions Repair 5Adjusting the return force of torsion spring

Page 7

P 7 / 26

Repair

[5]Adjusting the return force of torsion spring 28

1.Torsion spring 28 should be adjusted so that motor unit can smoothly return to the initial raised position from any other place.

Turning hex socket head set screw M6x16 with hex wrench allows to adjust the return force. See Fig. 5.

Fig. 5

Return force: Weak

Return force: Strong

Hex socket head set screw M6x16

[6] Assembling safety lock mechanism

Note: The products for the following countries are equipped with safety lock mechanism.

* Europe * South Africa

* China

1.Assemble the component parts of safety lock mechanism as illustrated in Fig. 6-1.

2.Holding the mounted compression spring 7 to lock lever, pass the lock lever through the loop portion of handle, and bring the safety lock mechanism between handle and blade case complete. See Fig. 6-2.

3.Pass lock pin through the large hole of lock plate.And lift up lock plate in order to align its screw holes with those of rod 8.Then, the lock pin's head comes to the keyhole slot of lock plate.And secure lock plate with pan head screw M4x10 to rod 8. See Fig. 6-3.

4.Secure rod holder with tapping screw bind CT 4x16, while pressing it toward blade case complete in order to make rod 8 parallel to handle as Fig. 6-4. Make sure that safety cover is locked with safety lock mechanism when lock lever is in the original position.

Fig. 6-1

Pan head screw M4x10

Compression

spring 7

Rod holder

Lock lever

Rod 8

Fig. 6-3

Fig. 6-2

Lock lever

Blade case complete

Handle

Fig. 6-4

Lock pin

Lock plate

Rod 8

Pan head screw

 

Lock pin's head unlocked

Lock pin's head locked

in keyhole slot

in the keyhole slot

Tapping screw bind CT 4x16

Rod holder

Image 7
Contents Technical Information SpecificationStandard equipment Optional accessoriesLubrication RepairRepair Page Stopper pin Assembling safety lock mechanism Repair 5Adjusting the return force of torsion springRepair Assembling safety cover section Repair Removing turn base from base Mounting square rod and securing ring Repair Mounting turn base to baseAssembling positive lock mechanism of turn base Repair Disassembling positive lock mechanism of turn baseRepair Mounting stopper plate to arm holder Adjusting arm for smooth pivot actionMounting ring 26 and set screw M4x8 Adjustment for max. cutting capacity Repair Angle adjustment of saw bladeRepair Angle adjustment of guide fence Laser circuit Assembling laser section exclusively for LS0714FL/ LS0714LMechanism for adjustment of the position of laser line Repair Page Repair Repair Brush Holder a Holder B LS0714FL with Fluorescent light and laser marker Wiring diagram in Handle LWiring diagram in handle L LS0714F with Fluorescent light Circuit diagram LS0714F with Fluorescent lightCircuit diagram LS0714 without Fluorescent light and laser Circuit diagram LS0714L with laser marker Wiring diagram in Handle L LS0714L with laser marker