P 18/ 26
Repair
(3) Adjustment of laser beam positioning (exclusively for LS0714FL/ LS0714L)
For safety and easy adjusting work, remove saw blade, safety cover section, flanges (outer and inner) and dust nozzle.
1.Mount Jig for laser line adjustment (1R315) to spindle. See Fig.
2.Tear away a part of laserline label until hex socket head set screws M4x6 (A and B) come into your sight as
3.Connect the machine with power source, and turn on the switch of laser. See Fig.
4.Slide the position of thumb screw M5x24 to the center point for the movable range in order to reserve the adjustment range to be wide. After that, drive the thumb screw M5x24 to fix the laser section.
Fig.
Switch of laser beam
Laser line label
Slide the position of thumb screw M5x24 to the center point for the movable range.
Hex socket set | Hex socket set |
screw M4x6 (A) | screw M4x6 (B) |
5.Lower the jig until it reaches the pan head screw M5x16 of link plate side. See Fig.
6.Move the laser line to the closest position to the line of jig by adjusting with hex socket set screw M4x6(A). See Fig.
Fig.
Line of jig
Laser line at the closest position to the line of jig.
Hex socket set screw M4x6 (A)
Be sure to turn hex wrench clockwise and slowly in
order to avoid backlash.