Makita BHR243 (LXRH02*1), BHR242 (LXRH01*1) specifications Correct Wrong

P 15/ 25

Repair

[3] DISASSEMBLY/ASSEMBLY

[3]-6. Impact bolt in Torque limiter section (cont.)

ASSEMBLING

(1) Assemble Impact bolt section to Tool holder (guide) complete as drawn in Fig. 44A/ 44B.

Fig. 44A

Impact bolt section in Tool holder complete for BHR242

Tool holder complete (140265-3)

Bit installation side

Note: These components are directional.

Sleeve 9B	Washer 10 Compression	O ring case B with
Impact bolt A	spring 20	O ring 9 fit inside
		Inner housing side

ø9mm ø9.5mm [cross-sectional view]

Fig. 44B

Impact bolt section in Tool holder guide complete for BHR243

Tool holder guide complete (140266-1) Sleeve 9B Washer 10

Impact bolt B

Bit installation side

long short Note: These components

are directional. [cross-sectional view]

Compression	O ring case B with
spring 20	O ring 9 fit inside
	Inner housing side

(2)Push Ring spring 28 into the inner groove of Tool holder (guide) complete as drawn in Fig. 45. Note: Do not reuse the removed Ring spring 28 if it is deformed or damaged.

Fig. 45

	Note: 1. Use an extra Piston cylinder as a jig. Never use Piston cylinder that is
	to be assembled to the machine.
Piston cylinder	2. The end gap of Ring spring 28 must not be placed at the two holes of
as a jig	Tool holder (guide) complete.

end gap Ring spring 28

Tool holder (guide)	Note: 1
	hole
complete	Piston cylinder as a jig
hole	Inner groove of
	Tool holder (guide)
	complete

Note: 2	[Correct]	[Wrong]	Ring spring 28	O ring case B
Tool holder Guide)
complete
Ring spring 28
end gap