P 24/ 25
Wiring diagram
Fig. D-3
BHR242, BHR243
Connect Lead wires to Controller/ Terminal with Flag receptacles as drawn below.
| Flag receptacles | |
Black | Black | |
lead wire | ||
lead wire | Red | |
White | ||
lead wire | ||
lead wire |
| |
Orange |
| |
lead wire |
| |
Controller | Terminal |
Terminal
Rib A
Do not put any lead wires on this boss.
Stator
Slacks of Lead wires between Controller and Connector/ Stator have to be placed over the line extended from Rib D.
Rib D
Line extended from Rib D
Rib C Do not put Stator lead wires on Rib C.
Lead wires to Connector have to be routed between Rib B and Rib D.
Controller Flag receptacles Rib B | Connector |
Set Controller in place with Flag receptacles faced as drawn above.
Lead wires to Connector and Stator lead wires have to be routed between Rib A and Rib B.
Route the lead wires between Connector and Controller to the bottom of Housing L so as not to rise on the top line of Rib C. Turn them back to set Connector in place. Place the turned portion over the line extended from Rib D.
Turned portion
Line extended from Rib D |
|
| |
The bottom of Housing L | Rib D | Connector | |
viewed from the upper side | |||
|
| ||
| Rib C |
|
Controller