Makita BHR243 (LXRH02*1), BHR242 (LXRH01*1) specifications Tool holder Leaf spring Change cover

P 7/ 25

Repair

[3] DISASSEMBLY/ASSEMBLY

[3]-1B. Holder section for BHR243 (cont.)

ASSEMBLING		Fig. 14
(1)	Assemble Torsion spring 31 to Tool holder as follows:	Torsion spring 31
		short arm
	• Set two Steel balls 6 on the holes of Tool holder.
	• Insert the short arm of Torsion spring 31 into the hole of Tool holder.	Tool holder
Note: Apply Makita grease No. RB No. 00 to two Steel balls 6 to prevent
	them from falling. (Fig. 14)
(2)	Assemble Change ring to Change cover. (Fig. 15)	long arm
(3)	Assemble Tool holder to Change cover. (Fig. 16)	Steel ball 6 (2pcs.)

Fig. 15			Fig. 16
			Insert the long arm of
			Torsion spring 31 into	Tool holder
Note:	[Section	a - a']	the hole of Change cover
			through the hole of	long arm of
Face the chamfered end			Change ring.	Torsion spring 31
of the hole upward.				Change cover
Align the hole of	a			Change ring
Change ring with	a'			75°
that of Change cover.		Change ring	By turning Tool holder
			approx. 75° clockwise,
			Tool holder can be fastened
			to Change cover.
		Change cover

(4)Put Steel ball 5.0 in the groove surrounded by Change cover and Tool holder. (left in Fig. 17)

(5)Set Leaf spring and Flat washer 24 in change cover, then secure them with Ring spring 21. (right in Fig. 17)

(6)As for Cap 35 side, assemble the components by reversing disassembly procedure. Refer to the previous page.

Fig. 17

Steel ball 5.0	Ring spring 21
Change cover	Flat washer 24
Tool holder	Leaf spring

Change cover