Makita BHR242 (LXRH01*1), BHR243 (LXRH02*1) specification

P 22/ 25

Repair

[3] DISASSEMBLY/ASSEMBLY

[3]-11. Tips on repair of Dust extraction system DX01, DX02

DISASSEMBLING

•Hose 30 is not glued on the other parts, and therefore it is possible to remove Hose 30 from Collector base A (DX01)/ B (DX02) and Inner pipe. (Fig. 69)

When it is difficult to remove because of the tight contact, peel it with a thin-slotted screwdriver. (Fig. 69)

Fig. 69

Hose 30

Collector base A/ B

ASSEMBLING

•Hose 30 is not glued on the other parts, and therefore it is possible to remove Hose 30 from Collector base A (DX01)/ B (DX02) and Inner pipe. (Fig. 69)

When it is difficult to remove because of the tight contact, peel it with a thin-slotted screwdriver. (Fig. 69)

•When reassembling Collector base A/B and Inner pipe, keep a right angle between them.

In assembly of housing L to R and shrinkage of Hose 30, while turning the hose 30 counterclockwise, snap the hooks of Collector base A/ B into the holes of Slide pipe as drawn in Fig. 70. (Reverse the step shown in Fig. 68.)

•While turning Hose 30 clockwise, adjust your desired positions of Hose, Collector base A/ B and Inner pipe each other.

The inner diameter of the spring of Hose is expanded, and consequently this way allows loose contact of Hose during revolving.

Fig. 70