ASSEMBLY
WARNING
Attaching the Belt Clip
WARNING
Recharge only with the charger specified for the battery pack. For specific charging instructions, read the operator’s manual supplied with your charger and battery pack.
Inserting Battery Pack into Tool
The battery pack may feel warm after the charging cycle. If it is warm, maximize the output of the battery by allowing it to cool for a few minutes before inserting it into the tool.
Battery pack can be inserted into the tool in two ways.
1.For working in restricted spaces, insert the battery pack from the front by sliding battery pack into the body of the tool. Insert the battery pack until the battery latches lock.
2.For optimum weight distribution and balance, insert the battery pack from the back by sliding the battery pack into the body of the tool. Insert the battery pack until the battery latches lock.
3.To remove the battery pack, press in both battery latches and slide the battery pack off of the tool.
WARNING
Always lock trigger or remove battery pack before changing or re- moving accessories. Only use acces- sories specifically recommended for this tool. Others may be hazardous.
WARNING
To reduce the risk of injury, always use a side handle when using this tool. Always brace or hold securely.
Installing the Side Handle
To install the side handle:
1.Loosen the side handle grip until the ring is large enough to slide over the torque selector collar.
2.Rotate the handle to 90° left or 90° right of the trigger handle.
3.Push the ring tightly against the side handle ribs on the tool. The indent in the side handle must fit over the appropriate rib.
4.Tighten the side handle grip securely.
5.To remove the side handle, loosen the side handle grip until the ring is large enough to slide off the tool.
Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool. Others may be hazardous.
Clip-LokTM System
The
Fig. 2 | Bit holder |
Tool holder
Front tangs | Clamp |
| release |
Belt clip |
|
Stud |
|
Pin | Clamp |
|
The belt clip can be mounted to tool belts, bags, buckets, etc. To mount the belt clip:
1.Pull up the clamp release. The clamp will pop out.
2.Slide the clamp over the tool belt, bag, bucket, etc.
3.Press in the clamp to tighten.
Using the Clip-Lok Tool Holder
1.To attach the tool to the belt clip, slide the tool holder over the stud on the belt clip until it is held in place by the protrud- ing pin.
2.To release the tool from the belt clip, grasp the tool handle, push down on the tool release lever with your thumb, and pull up on the tool.
Using the Clip-Lok Bit Holder
The bit holder holds two standard 1/4" hex shank bits up to two inches long.
1.Insert the bit by pressing it into the clip.
2.Remove the bit by lifting the tip of the bit and pulling it out of the clip.
Fig. 1
Side handle rib
Indent
90° left
6
Tool release lever
The system is shipped assembled for right- handed use. To change the assembly for
1.Remove battery pack.
2.Remove screws holding the tool holder and the bit holder.
3.Lift the holders at the narrow end and pull the front tangs out of their slots.
4.Replace the pieces onto the desired side by sliding the tangs into the slots. Tighten the screws securely.
7