Arbor/Chuck
Assembly
An arbor is included for the drill chuck that comes with this machine. The following procedure describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it is very difficult to separate the assembly. If you would like to use a different chuck in the future, we suggest using a different arbor.
Important: DO NOT install the drill chuck and arbor assembly until AFTER the test run.
To connect the drill chuck with the arbor:
1.Use acetone or lacquer thinner to clean drill chuck and arbor mating surfaces, especially the bore.
2.Retract the chuck jaws so that they are not exposed.
3.insert the arbor into the drill chuck.
4.hold assembly by the arbor and tap chuck onto a block of wood with moderate force (see Figure 8).
Figure 8. Installing arbor into chuck.
Initial Lubrication
GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
To prevent spillage, this machine was shipped from the factory without any oil in it. The head- stock oil reservoir must be properly filled with oil before the drill press can be operated for the first time. Refer to the Lubrication section, beginning on Page 33, for details on how to check and add oil.
Damage caused by running the drill press without oil in the reservoir will not be cov- ered under warranty.
Model G0756 (Mfg. Since 2/13) |