Precor P/N 300753-201 rev B manual Hour Meter, Event Description of Event Number

20		Operating and Maintaining the P20 Console
	Event	Description of Event
	Number
	22	No motor pulses at start up
	23	Motor pulses missing after start up
	24	Reduce speed requested, speed is not reducing
	26	Motor pulse width incorrect
	27	Too much drive motor current
	28	Temperature too high
	29	Excessive AC input current
	30	Communications event lower board to upper board
	31	Incorrect Communications event upper board to
		lower board
	32	Communication event upper board to lower board
	33	Incorrect communications event lower board to
		upper board
	40	Lift motion detected
	42	Lift position value out of range
	43	Zero switch not found
	44	Un-commanded lift motion
	45	Lift going in the wrong direction
	50	Too much brake (magnet) current
	53	Cannot read target, cannot find home switch
	54	Target pulses lost during operation
	55	Brake home switch activated unexpectedly
	60	Auto Stop sensor failure (treadmill)
	61	Auto Stop not present (treadmill)

Hour Meter

Tracks the number of hours that a piece of equipment has run. The equipment also tracks elapsed minutes, but the value that displays is rounded up the nearest full hour.