Assembling the Exercise Bike | 19 |
To install the upright support and prepare the cables for connection to the console:
1.Attach the lower ends of the following cables to the inner side of the jack panel:
Ethernet cable
Television cable (for P80 console)
Power cable (for P80 console)
2.Slide the jack panel back into its bracket in the right side cover.
3.Using a piece of tape or a plastic tie, bind together the upper ends of all cables.
4.While your assistant holds the upright support in place over the body assembly, thread the cables upward through the support. When you are finished, use a piece of tape to secure the upper connectors of the cables at the top of the support.
5.Slide the support into position so that its screw holes line up with the corresponding holes on the body assembly, as shown in the following illustration.
Note: If the support is positioned correctly, it rests on a metal tab in the upright support channel.
Figure 6: Upright support insertion
Important: In the following step, be extremely careful not to trap or pinch any of the cables between the mounting screws and their seats.