Parker Hannifin P/N88023735/01A manual Environment and Cooling

Page 25

Environment and Cooling

The Add-on modules operates in an ambient temperature range of 0°C (32°F) to 45°C (113°F). The modules can tolerate atmospheric pollution degree 2—only dry, non-conductive pollution is acceptable. Therefore, it is recommended that the cards be mounted in a suitable enclosure.

As you add modules, you must ensure that there are no hot spots created in the board stack due to airflow impairment.

Airflow impairment might result from cables coming in the way or lack of fan direction towards the stack. Record the temperature in several places (especially around I/O and DSP locations) to ensure even heat flow. Impaired heat flow might cause malfunctions and eventually lead to permanent loss of function.

Ambient Operating Temperature

0°C (32°F) to 45°C (113°F)

Storage Temperature

–40°C to 85°C (–40°F to 185°F)

Humidity

0–95%, non-condensing

Pollution Degree

2 (per IEC 61010)

Installation Category

2 (per IEC 61010)

Chapter 3 – Additional Specifications – 21

Image 25
Contents Page North America and Asia Parker Hannifin Corporation All Rights ReservedEurope non-German speaking Italy Table of Tables Important Information for Users Page Acrcomm MUX Flags Serial CommunicationsCOM Function Receive Flag Transmit Flag COM Function Receive/Transmit FlagsJumpers Acrcomm Hardware SetupJumper Description Signal Jumper Termination No TerminationCommunication Ports Termination Jumpers Autobaud Detect Jumper J7 Battery Enable Jumpers J5 and J6Autobaud Detect Jumper Function Signal Pin Communications-P5 ConnectorExpaxis Cables Expaxis OverviewExpaxis 9-16 Axis Expansion Board for the ACR1505 Encoder Inputs-XP1A, XP1B, and XP1C Encoder Pull-up Jumper Length of Cable/Type SettingXP1A Pinout XP1B Pinout Signal XP1A and XP1B ConnectorXP1C Pinout Signal XP1C ConnectorXP1C Y-Cable Pinout Signal Sub No XP9 ConnectorXP9 Pinout Definition XP10 Connector Hardware WiringF1 Fuse Analog I/O-XP2DXP2 Pinout Definition Module XP2 Analog I/O connector diagramModule Software Module Encoder Pull-ups OptionalEncoder Pull-Up Jumpers Resistor +5 VDC +12 VDC Additional Specifications Suggested Stacking of Modules Environment and Cooling Index