Sharp CV-P10LJ, CV-P13LJ operation manual How To Use The Remote Control, E-14

Page 15
HOW TO USE THE REMOTE CONTROL

HOW TO USE THE REMOTE CONTROL

Point the remote control towards the units signal receiver window and press the desired button. A beep will sound when the unit re- ceives the signal.

Make sure nothing, such as curtains, blocks the signal receiver window.

The remote control operates up to

23 feet (7 meters) away.

CAUTION

Do not expose the signal receiver window to direct sunlight. This may adversely affect its operation. If necessary, close the curtains to block out the sunlight.

Use of a fl uorescent lamp in the same room may interfere with transmission of the signal.

The unit may be affected by signals emitted from other remote controllers for tel- evisions, VCRs or other equipment used in the same room.

Do not leave the remote control exposed to direct sunlight or near a heater. Pro- tect the remote control from moisture and shock which can discolor or damage it.

To prevent the remote control from being misplaced, hook it to the unit when not in use.

When attached, to remove the remote control from the unit, lift the remote control up slightly and pull it out.

E-14 Remote control hook

E-14

Image 15
Contents CV-P10LJ CV-P13LJ PORTABLE TYPE ROOM AIR CONDITIONEREN GLI SH ES PA ÑO L CONTENTS NOTES ON OPERATION USAGE CAUTIONSTurn off the air conditioner when no one is home PRECAUTIONSLOCATION Keep the filter cleanSUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION INCLUDED3. Knife or scissors 55 Remote control signal receiver window PART NAMESFRONT VIEW REAR VIEW 33 Horizontal louvers 44 POWER Button79 ON TIMER Button REMOTE CONTROLREMOTE CONTROL DISPLAY 1 1 Transmitter 2 Display 3 POWER ButtonInstallation in a double-hungsash window INSTALL WINDOW PANELFoam seal A adhesive type Bracket Adjustment panel 24~36.8 Extension panel 36.8~48INSTALL WINDOW PANEL Installation in a sliding sash windowE-10 Unacceptable Acceptable Acceptable INSTALLATION AND REMOVAL OF EXHAUST HOSEInstallation of the exhaust hose E-11Removal of the exhaust hose E-12PUSH Projection PRE-OPERATIONCHECKS E-13LOADING BATTERIES Use two AAA R03 batteries E-14 HOW TO USE THE REMOTE CONTROL2 Press the POWER button to start opera- tion COOL MODEDEHUMIDIFICATION MODE E-15Press the POWER button to start operation E-16TO TURN OFF Press the POWER button again TO TURN OFF Press the POWER button againE-17 TO CHANGE AIR FLOW DIRECTIONUP / DOWN AIR FLOW DIRECTION LEFT / RIGHT AIR FLOW DIRECTIONPress the PLASMACLUSTER button during PLASMACLUSTER OPERATIONE-18 TO CANCELTO CANCEL MEGA COOL OPERATIONSLEEP OPERATION E-19E-20 TIMER OPERATIONON TIMER OFF TIMERPress the POWER button on the unit MAIN UNIT OPERATIONDRAINAGE E-21MAINTENANCE AFTER AIR CONDITIONER SEASON MAINTENANCECLEANING THE FILTER CLEANING THE UNIT AND THE REMOTE CONTROLAIR CONDITIONER DOES NOT OPERATE AT ALL BEFORE CALLING FOR SERVICEE-23 TIMER DOES NOT WORK PROPERLYTechnical Specifications E-24Condenser E-25Compressor EvaporatorTechnical Specifications E-26Condenser E-27Compressor EvaporatorDO NOT RETURN THIS DOCUMENT TO SHARP WARRANTYConsumer Electronic Products Congratulations on Your Purchase1300 SHARP APPROVED SERVICE CENTRESHARP APPROVED SERVICE CENTRE SHARP CUSTOMER SERVICESPage 66129905937