Sharp CV-P10LJ E-16, Ventilation Mode, Press the FAN button to set the desired fan, speed, Quiet

Page 17
FAN MODE
FAN MODE

In this mode, the air conditioner simply circulates the air without cooling it.

Ensure that the stopcock is securely attached to the drainpipe.

1

2 2

Press the MODE button to select FAN mode.COOL DEHUM FAN VENTPress the POWER button to start operation.The red OPERATION lamp on the unit will light.The temperature cannot be set.

 

Press the FAN button to set the desired fan

1

3 speed.

 

 

QUIET

LOW

HIGH

3

 

 

 

TO TURN OFF

Press the POWER button again.

• The red OPERATION lamp on the unit will turn off.

VENTILATION MODE

In this mode, the air conditioner ventilates the air to outdoors.

Ensure that the stopcock is securely attached to the drainpipe.

1

2 2

Press the MODE button to select VENT mode.

COOL DEHUM FAN VENT

Press the POWER button to start operation.

The red OPERATION lamp on the unit will light.

The temperature cannot be set.

3 Press the FAN button to set the desired fan speed.

1

• Although the louvers are closed and no air blows

out into the room, the external ventilation fan

3

speed changes.

 

 

QUIET

LOW

HIGH

 

TO TURN OFF

Press the POWER button again.

• The red OPERATION lamp on the unit will turn off.

E-16

Image 17
Contents EN GLI SH ES PA ÑO L CV-P10LJ CV-P13LJPORTABLE TYPE ROOM AIR CONDITIONER CONTENTS NOTES ON OPERATION USAGE CAUTIONSLOCATION PRECAUTIONSKeep the filter clean Turn off the air conditioner when no one is home3. Knife or scissors SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATIONINCLUDED FRONT VIEW REAR VIEW PART NAMES33 Horizontal louvers 44 POWER Button 55 Remote control signal receiver windowREMOTE CONTROL DISPLAY REMOTE CONTROL1 1 Transmitter 2 Display 3 POWER Button 79 ON TIMER ButtonInstallation in a double-hungsash window INSTALL WINDOW PANELFoam seal A adhesive type Bracket Adjustment panel 24~36.8 Extension panel 36.8~48INSTALL WINDOW PANEL Installation in a sliding sash windowE-10 Installation of the exhaust hose INSTALLATION AND REMOVAL OF EXHAUST HOSEE-11 Unacceptable Acceptable AcceptablePUSH Projection Removal of the exhaust hoseE-12 LOADING BATTERIES Use two AAA R03 batteries PRE-OPERATIONCHECKSE-13 E-14 HOW TO USE THE REMOTE CONTROLDEHUMIDIFICATION MODE COOL MODEE-15 2 Press the POWER button to start opera- tionTO TURN OFF Press the POWER button again E-16TO TURN OFF Press the POWER button again Press the POWER button to start operationUP / DOWN AIR FLOW DIRECTION TO CHANGE AIR FLOW DIRECTIONLEFT / RIGHT AIR FLOW DIRECTION E-17E-18 PLASMACLUSTER OPERATIONTO CANCEL Press the PLASMACLUSTER button duringSLEEP OPERATION MEGA COOL OPERATIONE-19 TO CANCELON TIMER TIMER OPERATIONOFF TIMER E-20DRAINAGE MAIN UNIT OPERATIONE-21 Press the POWER button on the unitCLEANING THE FILTER MAINTENANCECLEANING THE UNIT AND THE REMOTE CONTROL MAINTENANCE AFTER AIR CONDITIONER SEASONE-23 BEFORE CALLING FOR SERVICETIMER DOES NOT WORK PROPERLY AIR CONDITIONER DOES NOT OPERATE AT ALLTechnical Specifications E-24Compressor E-25Evaporator CondenserTechnical Specifications E-26Compressor E-27Evaporator CondenserConsumer Electronic Products WARRANTYCongratulations on Your Purchase DO NOT RETURN THIS DOCUMENT TO SHARPSHARP APPROVED SERVICE CENTRE SHARP APPROVED SERVICE CENTRESHARP CUSTOMER SERVICES 1300Page 66129905937