INSTALL WINDOW PANEL
Installation in a double-hung sash window
(See page 9 for installation in a sliding sash window. )
Hole
1 Connect the rain guards to the insect guard net.
Insert all three projections on each rain guard into the holes in the insect guard net.
Side “A” will now be uppermost, as indi- cated in the diagram.
2 Attach the guard combined above to the window panel
Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel.
Side “A” will now be at the top, as indicated in the diagram.
3 Cut the foam seal A (adhesive type) to the proper length and attach it to the window stool.
4 Attach the window panel to the window stool.
If the inner width of the window is be- tween 22" (559mm) and 24" (609mm) inclusive.
The window panel cannot be installed in windows less than 22" (559mm) wide, as you will be unable to shut the exhaust cover.
(1)Remove the adjustment panel from the window panel, and cut the window panel to the same width as the window.
(2)Open the window sash and place the window panel on the window stool
(3)Secure the window panel to the window stool with 2 screws.
Insect guard net
Projection
"A"
22"~ 24"
Rain guard
"A"
Projection
Window panel
Foam seal A (adhesive type)
Cut
Window panel
Window stool