Aegis Micro NRC 2.0.1 manual Users’ Guide Networked Receiver Controller NRC-2.0.1

Page 21

The LCD display symbols are listed – from highest to lowest priority, along with their meaning in the following table.

The NRC is not configured for this channel; Configure the correct receiver for this channel.

The receiver attached to this channel is currently offline.

-Caused when the NRC is unable to communicate with the receiver via the RS-232 connection.

-Check the receiver and its NRC connections, whether the receiver is powered on, and whether the receiver is operational or needs to be reset or needs the power cycled.

The receiver attached to this channel failed an integrity test.

-Caused when a receiver is able to communicate with the NRC, but fails to respond as expected when

tuned to provide a self-test audio tone to the NRC unit.

-Check the receiver’s RS-232 and audio connections to the NRC match and then reboot/re-power the receiver and/or the NRC.

A client is currently connected to this channel and is receiving data from this channel.

A client is currently connected to this channel.

This channel is fully functional and available for use.

When the NRC is configured and operating correctly symbols , and will be most often displayed.

Users’ Guide: Networked Receiver Controller - NRC-2.0.1

PAGE 21

11th October 2005

Copyright © 2005 Aegis, Inc

wwww.aegis-inc.net [ph. 240-568-9006]

Image 21

Contents Networked Receiver Controller NRC-2.0.1 Proprietary Statement Table of Contents TEN-TEC RX-331 General Information Audio Data Capture Channel ArchitectureUniversal Receiver Translation/Abstraction Capabilities Summary Receiver Controllable Settings Client Connection OptionsSystem Hardware Supported Receivers SpecificationsTh October Copyright 2005 Aegis, Inc Contents InstallationHardware Installation NRC Configuration PrerequisitesConnect to the NRC Change Administrator Password Set the Time and Date Configure Network SettingsConfigure the Network Time Daemon Optional Restart the NRC Set the Host NameUsers’ Guide Networked Receiver Controller NRC-2.0.1 Configure the NRC for Receivers Power-On Self Test Post Using the NRCStarting the NRC Interpreting the LCD DisplayUsers’ Guide Networked Receiver Controller NRC-2.0.1 Connect to NRC Server Dialog Requirements Running the NRC Java ClientMain Application Window TreeNRC Servers Node Content PanelUsers’ Guide Networked Receiver Controller NRC-2.0.1 Channel Node Users’ Guide Networked Receiver Controller NRC-2.0.1 Users’ Guide Networked Receiver Controller NRC-2.0.1 Toolbar Status Bar Change Receiver Model Dialog Change Antenna Model Dialog NRC Properties Dialog Destination OptionsCapture Channel Data Dialog Signal Display Dialog Th October Copyright 2005 Aegis, Inc BAE Systems WJ-8723 Appendix A- Receiver ConfigurationNRC File System Appendix B Software UpgradesRestore Command Update CommandUpgrade Procedure Clean CommandUsers’ Guide Networked Receiver Controller NRC-2.0.1 Users’ Guide Networked Receiver Controller NRC-2.0.1