Aegis Micro NRC 2.0.1 manual Users’ Guide Networked Receiver Controller NRC-2.0.1

Page 27

￿￿Query – This button allows you to query the receiver to find out which parameters are stored in memory. Some receiver types also support the ability to display what values are currently stored at a specific memory location. Below is a query on a WJ receiver.

￿￿Load – This option loads the receiver configuration from the specified memory location into the receiver’s current configuration. If nothing is stored at the memory location the behavior of this operation is dependant on the type of receiver. Some receivers may ignore the command or load a default configuration, or for example.

￿￿Save – This option saves the receiver’s current configuration to the specified memory location. The number of locations varies with each type of receiver. It is important to note that the volatility of the memory is also dependant on the type of receiver. Some receivers may clear all saved settings if the “ Reset Rx” button is pressed, others may maintain the memory until the receiver is powered down.

Note: Different receivers store different attributes and hence there is no uniform list of options which are saved for all receivers, with not even the basic frequency, detection mode, AGC mode, BFO and IF Bandwidth parameters saved for all receivers.

oReceiver Pass thru Command

An ACSII-based text command can be sent directly to the receiver using the “ Pass-thru command” . Enter the command string into the corresponding text field and press Enter or click “ Send” . Please refer to the receiver operator’s manual for the valid command set for each receiver. If the “ Response” box is checked, then an ASCII response is

Users’ Guide: Networked Receiver Controller - NRC-2.0.1

PAGE 27

11th October 2005

Copyright © 2005 Aegis, Inc

wwww.aegis-inc.net [ph. 240-568-9006]

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Networked Receiver Controller NRC-2.0.1 Proprietary Statement Table of Contents TEN-TEC RX-331 General Information Audio Data Capture Channel ArchitectureUniversal Receiver Translation/Abstraction Capabilities Summary Receiver Controllable Settings Client Connection OptionsSystem Hardware Supported Receivers SpecificationsTh October Copyright 2005 Aegis, Inc Contents InstallationHardware Installation NRC Configuration PrerequisitesConnect to the NRC Change Administrator Password Set the Time and Date Configure Network SettingsConfigure the Network Time Daemon Optional Restart the NRC Set the Host NameUsers’ Guide Networked Receiver Controller NRC-2.0.1 Configure the NRC for Receivers Interpreting the LCD Display Using the NRCPower-On Self Test Post Starting the NRCUsers’ Guide Networked Receiver Controller NRC-2.0.1 Connect to NRC Server Dialog Requirements Running the NRC Java ClientMain Application Window TreeNRC Servers Node Content PanelUsers’ Guide Networked Receiver Controller NRC-2.0.1 Channel Node Users’ Guide Networked Receiver Controller NRC-2.0.1 Users’ Guide Networked Receiver Controller NRC-2.0.1 Toolbar Status Bar Change Receiver Model Dialog Change Antenna Model Dialog NRC Properties Dialog Destination OptionsCapture Channel Data Dialog Signal Display Dialog Th October Copyright 2005 Aegis, Inc BAE Systems WJ-8723 Appendix A- Receiver ConfigurationNRC File System Appendix B Software UpgradesRestore Command Update CommandUpgrade Procedure Clean CommandUsers’ Guide Networked Receiver Controller NRC-2.0.1 Users’ Guide Networked Receiver Controller NRC-2.0.1
Top Page Image Contents