Details of the modes are given below.
Item
Details
PROGRAM Mode | All the programs are executed. |
PROGRAM GROUP | Only the programs selected by PROGRAM GROUP EDIT |
Mode | are executed. |
*For details on PROGRAM GROUP EDIT, refer to ???
on page ???.
7.3.3Adjusting the speaker volume
Use the rotary key to adjust the volume of the
PAGE 2 [F3] → [F1 or F2] to select SPEAKER VOLUME → [ENTER] to enter selection
→[Rotary key] to adjust SPEAKER VOLUME value.
*Either 2 channels (1 stream) of a maximum of 8 channels (4 streams) with frequencies from 32 to 96 kHz for linear PCM only or both channels of 2 channels with frequencies from 176.4 to 192 kHz can be output as the sound.
7.3.4Setting the hot plug button
PAGE 2 [F3] → [F1 or F2] to select HOTPLUG MODE → [ENTER] to enter selection
The settings available when the HOTPLUG button is pressed can be performed.
Item
Details
AUTO MODE | Low changes to high when the button is pressed once. |
| Any time from 10ms to 200ms can be selected at the low |
| period. Use the rotary key to select it. |
| * This length also applies to changes in the hotplug signals |
| when other processes are undertaken. |
MANUAL MODE | The level is reversed when the button is pressed once. |
|
|
*In MANUAL MODE, the value selected using MANUAL is retained even when the hotplug signal must be changed (such as while EDID is being changed) during normal operation. For this reason, the mode should normally be kept at AUTO MODE.
27