HP Scripting Toolkit for Windows and Linux manual Network Settings-IPv6

4.Edit the setting(s) as necessary. Click Apply.

Network Settings–IPv6

•iLO Client Applications use IPv6 first—When both IPv4 and IPv6 service addresses are configured for iLO client applications, this option specifies which protocol iLO tries first when accessing a client application. This setting also applies to lists of addresses received from the name resolver when using FQDNs to configure NTP.

◦

◦

Select this check box if you want iLO to use IPv6 first.

Clear this check box if you want iLO to use IPv4 first.

If communication fails using the first protocol, iLO automatically tries the second protocol.

•Enable Stateless Address Auto Configuration (SLAAC)—Select this check box to enable iLO to create IPv6 addresses for itself from router advertisement messages.

NOTE: iLO will create its own link-local address even when this option is not selected.

•Primary DNS Server, Secondary DNS Server, Tertiary DNS Server—Enter the IPv6 addresses for the DNS service.

When DNS server locations are configured in both IPv4 and IPv6, both sources are used, with preference given according to the iLO Client Applications use IPv6 first configuration option, primary sources, then secondary, and then tertiary.

•Use DHCPv6 Supplied NTP Servers—Specifies whether iLO uses the DHCPv6 server-supplied time.

•Enable DDNS Server Registration—Specify whether iLO registers its IPv6 address and name with a DNS server.

•Static IPv6 Address 1—4– Enter up to four static IP addresses if they are not automatically assigned. You must specify the prefix length for the addresses.

•Static Default Gateway—Enter a default IPv6 gateway address for cases in which no router advertisement messages are present in the network.

•Static Route #1 (Destination/Gateway), Static Route #2 (Destination), Static Route #3—Enter static IPv6 route destination prefix and gateway address pairs. You must specify the prefix length for the destination. Link-local addresses are not allowed for the destination, but are allowed for the gateway.

To edit the settings on the IPv6 tab:

1.In the iLO Configuration Utility window, click Network Settings. The General tab data appears.

2.Click the IPv6 tab. The IPv6 tab data appears.

62 Using Intelligent Provisioning