10.If the computer includes a game console cover, press the side tab and remove the game console cover.
11.Remove the 13 screws that secure the back cover to the computer, as follows:
●three under each side panel
●three in the I/O connector area
●two at the bottom of the back cover
●two near the optical drive
12.Lift the back cover off the computer.
To install the back cover, reverse the removal procedures.
When installing the back cover, note that the back cover has several tabs at the top of the cover that fit into slots in the top inside of the computer.
Graphics card
1.Prepare the computer for disassembly (see Preparing to disassemble the HP TouchSmart PC on page 11).
2.Place the computer face down on a soft, flat surface.
3.Remove the hard drive/memory cover (see Hard drive/memory cover on page 12).
4.Remove the stand (see Stand on page 15).
5.Remove the I/O cover (see I/O cover on page 13).
6.Remove the feet (see Feet on page 14).
7.Remove the back cover (see Back cover on page 20).
22 Chapter 4 Removal and Replacement Procedures