HP 9100 manual System Recovery, Creating Recovery Discs, Choosing Recovery Discs

Page 57

7 System Recovery

System recovery completely erases and reformats the hard disk drive, deleting all data files you have created. System recovery reinstalls the operating system, programs, and drivers. However, you must reinstall any software that was not installed on the computer at the factory. This includes software that came on CDs included in the computer accessory box, and software programs you installed after purchase.

You must choose from the following methods for performing a System Recovery:

Recovery Image—Run the system recovery from a recovery image stored on your hard disk drive. The recovery image is a file that contains a copy of the original factory-shipped software. To perform a system recovery from the recovery image on your hard disk drive.

NOTE: The recovery image uses a portion of the hard disk drive that cannot be used for data storage.

Recovery Discs—Run the system recovery from a set of recovery discs that you create from files stored on your hard disk drive.

Creating Recovery Discs

Complete the procedure described in this section to create a set of recovery discs from the recovery image stored on your hard disk drive. This image contains the operating system and software program files that were originally installed on your computer at the factory.

You can create only one set of recovery discs for your computer. Furthermore, the recovery discs you create can be used only with your computer.

Choosing Recovery Discs

To create recovery discs, your computer must have a DVD writer.

Use DVD+R or DVD-R blank media to create your system recovery discs.

You cannot use DVD+RW, DVD-RW, DVD+RW DL, DVD-RW DL, DVD+R DL, DVD-R DL, or CD discs to create recovery discs.

Use high-quality discs to create your set of recovery discs. The verification standard for the recovery disc creation process is very high. You may see error messages such as Recording failure when writing disc or Error detected during disc verification.

Your discs may be rejected if they are not defect-free. You will be prompted to insert a new blank disc to try again. It is normal that some of your discs may be rejected.

Creating Recovery Discs 51

Image 57
Contents Maintenance and Service Guide Maintenance and Service Guide About This Book Iv About This Book Table of contents Computer Setup F10 Utility Product Description Front and right side ComponentsFront and right side Lower left-side components Rear components Rear componentsActivity LED indicator lights Computer stand Processors and system board Spare PartsDrives MemoryPower Adapters Misc BoardsKeyboards and Mice Misc Parts Preparing to disassemble the HP TouchSmart PC Removal and Replacement ProceduresHard drive/memory cover Cover Feet Stand Adding Memory Before you beginRemoving a memory module Page Page Removing the hard drive Back cover Page Graphics card Page Wlan module Page TV tuner module Page Page Remove the hard drive see Removing the hard drive on System boardPage Processor Page Bluetooth module Page Optical drive Synchronizing the wireless keyboard or mouse Page Installing a Security Lock Computer Setup F10 Utility Computer Setup F10 UtilitiesUsing Computer Setup F10 Utilities 1Computer Setup F10 Utility Main Menu Computer Setup-Main2nd Drive Computer Setup-AdvancedROM Computer Setup-PowerS5 Maximum Power Computer Setup-BootComputer Setup-Exit Bios updatesSoftware Troubleshooting Software Repair OverviewUpdating Drivers Software Program and Hardware Driver Reinstallation Microsoft System RestoreUnder Programs, click Uninstall a program Creating data backup discs Clearing Bios passwordsClearing Cmos Power-On Self Test Post Determining Whether Your System Is 64-bit or 32-bit TroubleshootingSystem Recovery Creating Recovery DiscsChoosing Recovery Discs System recovery from the Windows 7 Start menu System Recovery OptionsStarting system recovery from recovery discs System recovery at system startupPage Index Sodimm
Related manuals
Manual 4 pages 40.35 Kb Manual 4 pages 6.15 Kb