Chapter 1 - Installation and Configuration | Software Configuration |
VEE Runtime I/O Configuration
You must complete these steps for the Sofware to communicate with your network analyzer!.
1. Click Start
2. Turn on you Network Analyzer and Click the “Find Instruments button.
3. You should see your network analyzer appear in the list
The instrument number consists of the GPIB controller ID number and the Instrument number
Example: ID (newinstrument@1416) 14=Nat inst
GPIB controller 16=Analyzer ID #
4.Select your analyzer from the list and Click on the “Properties button” You should see the window to the right, Change the name that is shown to one from the list below that matches your analyzer.
Network Analyzer | “Name” setting |
HP 8510 series Analyzers | HP8510 |
HP 8714 series Analyzers | HP8714 |
HP 8720 series Analyzers | HP8720 |
HP 8753 series Analyzers | HP8753 |
HP 5071 series Analyzers | HP5071 |
Anritsu Scorpion Analyzers | Scorpion |
Rhode & Schwarz RS series | RSZVR |
Signal Generator | “Name” setting |
HP 83650B Signal Gen. | HP836 |
HP 8350 Sweep Generator | HP8350 |
Spectrum Analyzer | “Name” setting |
HP 8565 Series | HP8565 |
Power Meter
HP 436A Power Meter
HP 437B Power Meter
Anritsu ML2438A
Anritsu ML4803A
“Name” setting HP436
HP437
ML2438
ML4803
DPM10
5.Press the “Advanced” button to bring up the Advanced Properties Dialog Box.
Set the Instrument Timeout to 15 seconds. Press OK , then OK, then “SAVE”. You have now successfully completed the Analyzer Configuration Process.
18