HP 6000 manual System Calibration, Performing a Scalar Calibration

Page 36

Chapter 3 - Making Measurements	System Calibration
Important---- If you are using a VNA this information does not apply to you.
Performing a Scalar Calibration

1.Be sure Platform Power supply is securely attached and plugged in

3.Turn Platform Power ON.

4.Selet the Source Instrument you plan to use, After selection click the “Settings” button located below the icon.

5.Click the “Cal System button

6.Connect the power meter to the top of the DAMs System.

7, Press the left “Begin Calibration” button, Follow on screen directions.

36

Image 36

Contents Desktop Antenna Measurement System Model Page Table Of Contents Page Page Introduction Features Key FeaturesRequirements Minimum System RequirementsUSB Port Platform Controller Unit Platform Controller rear view Platform Controller top viewParallel Port Platform Controller Unit Control Unit Front View Control Unit Side ViewPage Package Contents Unpacking the SystemTripod Assembly Tripod and Elevation Unit AssemblyVertical Assembly Platform Assembly Connecting the platform and vertical actuatorCable Connections Attaching the cablesSoftware and Hardware Installation Installing the SoftwareSoftware Configuration LPT Parallel Port Driver Installation InstructionsOverview StepNetwork Analyzer Name setting Signal Generator Name settingSpectrum Analyzer Name setting Power MeterTripod Compatibility Information System Test Platform Positioning TestInstallation Notes Special Installation NotesScreen Sleepers and Power Saving options Other Running ApplicationsPage Chapter Measurement Settings Measurement Settings Instrument Selection and SettingsSource Instrument Settings Only instrument Receive Instrument -Power Meter SettingsMeasurement Settings Measurement Settings Azimuth setupElevation setup Platform Settings and CalibrationCalibration Settings Calibration Settings Scalar CalibrationPower Sensor Calibration Measurement Controls Measurement ControlsMeasurement Status and Displays Meaurement Status and Displays Measurement Status windowGraphical Status Displays Data Processing Data Processing IntroductionData Registers Active RegisterData Processing Dynamic Amplitude Plot Measurement Calculator Dipole Link SimulatorVertical Swing Correction Page System Calibration Performing a Scalar CalibrationBasic Measurements Making a basic Horizontal/Azimuth MeasurementMaking a basic Vertical/Elevation Measurement Az/El Scan Measurements Performing an AZ/EL Scan MeasurementPage Data Processing Screenshot IntroductionData Processing Feature Viewing and working with measurements in 3D To Print a PlotTo Label a Plot To Export as BMP Image File- Click File ExportViewing and working with the Dynamic Amplitude Plot InstructionsDynamic Amplitude Plot Screenshot Viewing and working with the Polar Plot display Polar Plot ScreenshotUsing the Measurement Calculator / Register Math Function Register Math / Calculator ScreenshotUnderstanding the Register Math Functions Math FunctionsLinear LinMag LogMagData Processing Feature Exporting DataMeasurement Export Process Measurement Export Process Contd Using the Dipole and Isotropic Link Calculator Using the Dipole and Isotropic Link Calculator Contd Group Delay Screenshot Page Page Troubleshooting and Service Troubleshooting OperationTroubleshooting Service and Contact Info

Related manuals

Manual 61 pages 62.96 Kb