HP 6000 manual Platform Assembly, Connecting the platform and vertical actuator

Chapter 1 - Installation and Configuration Platform Assembly

Connecting the platform and vertical actuator.

1.Ensure that the Azimuth of the tripod is unlocked.

2.Place the Tripod head in a horizontal position and tighten the locking screw (Loosen screw after

assembly)

3.Align the colored piece of tape on the platform with the tape on the tripod head and insert the platform into the head at a

30degree angle, the head will automati- cally lock the platform into position.

4.Loosen the Tilt Lock (Pic 2) enough to allow the platform to tilt and connect the vertical actuator rod to the platform , tighten the locknut to ensure the rod does not disconnect.

Attaching the optional thrust plate- Applies to Acrylic and Aluminum models.

Attach the Thrust Plate using the 4 includeded

10-32x1/4” Screws. be sure not to overtighten screws and if using your own screws be sure they do not hit the metal bearing below.

14