HP FCA2404 AB232A AB232A manual Lists the current parameters that you can set

Diagnostic and Configuration Utilities

Table 8 lists the current parameters that you can set.

Table 8: Drive Parameters

Parameter	Description
AbortStatus = 0xn	Values from 0x00 – 0xFF. Controls NT SRB error status
	for general Abort conditions.
	Default = SRB_STATUS_BUS_RESET (0x0E) which will
	not cause the current NT class driver to throttle down I/O
	performance after four of these errors have been
	received (on a per-LUN basis).
ALTOV = n	Values are in milliseconds from 1 to 15. Default = 15.
ARBTOV = n	Values are milliseconds from 500 to 10000. Default =
	1000. Represents FC_AL arbitration time-out prior to LIP.
Class = n	Values from 0 to 2. Default = 2. Controls which Fibre
	Channel Class will be used: 0 = Class 1, 1 = Class 2, 2 =
	Class 3.
EDTOV = n	Values are in milliseconds from 500 to 10000. Default =
	1000. Represents error detect time-out value prior to LIP.
EnableDPC = n	Values 0 or 1. Default = 0. 0 = process I/O completion at
	interrupt level, 1 = process at DPC level.
FrameSizeMSB = n	Values from 1 – 8. Default = 8. Controls the upper byte of
	the receive FrameSize if issued in PLOGI. This allows the
	FrameSize be constrained on 256 byte increments from
	256 (1) – 2048 (8).
HardALPA = 0xn	Values from 0x01 – 0xEF. Default = 0x01 allows the HBA
	use a hard assigned loop address. NOTE: Only valid
	ALPAs can be used (see Table 9 on page 44).
LinkTimeOut = n	Values are in seconds from 1 – 500. Default = 60.
	Controls the time-out at which link no longer busy with
	requests but issues SELECTION_TIMEOUT error status.
LogErrors = n	Values 0 or 1. Default = 0. 0 = don’t log general
	HBA/drive errors. 1 = use Event Log to log general
	errors.
NodeTimeOut = n	Values are in seconds from 1–255.
	Default = 10. Controls the time-out at which a formerly
	logged-in node will issue SELECTION_TIMEOUT error
	status to an I/O request.

AB232A PCI-X Host Bus Adapter Installation Guide 41