HP FCA2404 AB232A AB232A manual Diagnostic and Configuration Utilities

	Diagnostic and Configuration Utilities
Table 8: Drive Parameters (Continued)
Parameter	Description
SilFlags = n	Values from 0-2. Default = 0. Controls which driver
	interface to use. 0 = automode; attempt SLI-2 first. If that
	fails, uses SLI-1. 1 = always use SLI-1. 2 = always use
	SLI-2.
SimulateDevice = n	Values 0 or 1. Default = 0. 0 = do not create a “dummy”
	disk device. 1 = create a dummy disk to force the driver
	to load even if no disk devices are present at boot time.
SnsALL = n	Values 0 or 1. Default = 1. Controls which N_Ports are
	queried from the NameServer. 0 = SCSI FCP only. 1 = All
	N_Ports.
Topology = n	Value 0 through 3. Default = 2. 0 = FC_AL (loop), 1 =
	PT-PT Fabric, 2=FC-AL first, then attempt PT-PT,
	3=PT-PT first, then attempt FC-AL. When set to 1,
	FLOGI, SCR/RSCN and NameServer queries are
	employed.
TrafficCop = n	Values 0 or 1. Default = 0. 1 = enable FC-AL loop master
	to run unfair and break potential arbitration problems by
	sending frames to itself. 0 = run fair all the time.

AB232A PCI-X Host Bus Adapter Installation Guide 43