HP book XE2 Removing Other Components, Removing Display Components, Removing Top Case Components

Removing Other Components

(HP Authorized Service Providers Only)

Required Equipment

∙Small Phillips screwdriver.

∙Pointed knife or probe (for display components).

∙5-mm hex driver (or 3/16 inch) (for bottom case components).

Removal Procedure

1.Unplug the AC adapter, if present, and remove the battery.

2.Remove the additional assemblies and follow the special steps indicated in the tables below. Components are separated into these groups:

∙Display components.

∙Top case components.

∙Bottom case components.

Table 2-7. Removing Display Components

Component

Display Bezel

Display Case

Hinge

Hinge Cover

Inverter PCA

LCD Brackets (part of LCD kit)

LCD Flex Cable

LCD Module

Removal Procedures

Display (page 2-11)

LCD module (page 2-12).

Display (page 2-11). LCD module (page 2-12).

Display (page 2-11). LCD module (page 2-12).

Display (page 2-11).

Display (page 2-11). LCD module (page 2-12).

Display (page 2-11). LCD module (page 2-12).

Display (page 2-11). LCD module (page 2-12).

See page 2-12.

Additional Steps (See figure on page 4-3)

Remove the display bezel (page 2-12)..

Remove the LCD module and brackets from the case, but do not disassemble the module (page 2-12).

Remove the display bezel (page 2-12).

1.Remove the display bezel (page 2-12).

2.Unplug both cables attached to or holding the inverter PCA. Lift up the PCA if necessary.

Component

Keyboard

Top Case

Component

Battery

Table 2-8. Removing Top Case Components

Removal Procedures Additional Steps

See page 2-9.

See page 2-15.

Table 2-9. Removing Bottom Case Components

Removal Procedures Additional Steps (See figures on pages 4-2, 4-4)

See page 2-3.

HP OmniBook XE2 Removal and Replacement 2-21